ATIM ACW-SF8 Manuel d'installation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} ATIM ACW-SF8. ATIM ACW-SF8 10 pages. Atim cloud wireless - metering 2 digital inputs – 1 wirecut input

Imprimer la page

IDENTIFICATION

You can connect:

CNTR 1: One dry-contact fast meter input (max 1 kHz): "Counter 1" or 1 digital input

•

WIRECUT: 1 dry-contact for to monitor disconnection/cut wire. This input is monitored

•

once/min.

CNTR 2: 1 dry-contact slow meter input (max 10 Hz): "Counter 2" or 1 digital input

•

GND: Ground

•

The sensor ID is visible on the exterior product label and next to the batteries inside the device.

ACW-MR2_QIG_FR_V2.5

The battery polarity is indicated on the circuit

board. The + pole points toward the terminal block

and the – pole toward the antenna. The insulation

tab must be pulled out from one of the battery

terminals before you first use the device.

If a second battery is added, it must be added in

parallel, in the same direction as the first battery.

Start-up phases:

From 0 to 3 sec: bootloader.

From 3 sec to 8 sec: configuration

From 8 sec to 10 sec: configuration is applied, green

LED flashes, red LED flashes if Wirecut is detected.

After 15 sec: switches to stand-by

From 1 min to 5 min: keep-alive frame sent out for

the 1

The keep-alive frame is then transmitted every 4

days.

- Complete technical manual available at www.atim.com -

minute, then a message frame every minute.