Bosch WTY877W0AU Manuel d'installation et d'utilisation - Page 37
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Bosch WTY877W0AU. Bosch WTY877W0AU 44 pages.
Imprimer la page
3
Faults and what to do about them
F a u l t s a n d w h a t t o d o a b o u t t h e m
Faults
Please empty the con-
densate container on
the display panel and the
drying cycle is inter-
rupted.
Please clean the fluff
filters on the display
panel.
Heat exchanger is
being rinsed on the dis-
play panel.
Dryer does not start.
Creasing.
Water is leaking out.
Change in the pro-
gramme duration dis-
played during drying.
* Depending on the model
Cause/remedy
Empty the condensate container; ~ Page 33 and the dryer; ~ Page 17.
■
If the optional condensation drain* is installed, the drain hose may be
■
blocked or kinked. Check the hose for deposits and rinse the hose. Lay the
hose without any kinks.
Clean the fluff filter and press the Start button ~ Page 32.
Not a fault. The heat exchanger is cleaned automatically. Do not pull out the
condensate container while this is displayed.
Mains plug plugged in or fuse checked?
■
Programme selected? Select a programme.
■
Dryer door open? Close the door.
■
Childproof lock activated? Deactivate the childproof lock.
■
"Ready in" time selected? Programme starts after a delay ~ Page 28.
■
Creasing occurs when you have exceeded the maximum load or selected
■
the wrong programme for the type of fabric. All the required information
can be found in the programme table ~ Page 26.
Remove clothes immediately after drying; creasing may occur if they are
■
left in the drum.
Not a fault; the dryer may be positioned on an incline. Level the dryer.
Not a fault. The moisture sensors detect the remaining moisture in the load and
adjust the programme length (except timed programmes).
Faults and what to do about them
en
37