Ativa HD PRO 1400 Manuel de l'utilisateur - Page 3
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Ativa HD PRO 1400. Ativa HD PRO 1400 10 pages.
Imprimer la page
This unit is equipped with Jam-Alert technology. The Jam-Alert icon
(F) will turn red after the machine has gone into reverse indicating
that the maximum sheet capacity has been exceeded. Reduce the
number of sheets and place the paper back into the paper feed slot.
OVERHEAT
This unit is equipped with a cool down guide (D). As you shred, the cool down icons
will illuminate to alert you to how close the unit is to overheating and needing to cool
down. The cool down icon will appear to signal that you have shredded beyond the
maximum continuous shred time. In this case, unplug the machine and allow it to
cool down to room temperature. Once the machine has cooled, plug the unit back
into a grounded electrical outlet and continue with normal operation.
BIN FULL
When waste bin is full, a green "Full" light will flash (I).
STANDBY MODE
The shredder is equipped with an energy saving standby mode which will activate
after 30 minutes of being idle. To resume, pass the power button (B).
MAINTENANCE
To ensure proper operation and function, periodic oiling of the cutting system is
required. Failure to oil your cutting system could result in reduced sheet capacity
performance, excess noise, paper jams and possible machine failure.
th
th
Oil your cutters every 5
-6
time you empty the basket if excess squeaking and
rubbing noise is coming from the machine or if the shredder's sheet capacity has
diminished.
Run the machine in reverse after every 15-30 minutes of continuous use while
applying a thin strip of oil to the cutting head.
-Squeeze the lubricant across the full width of the cutters.
-Flip the switch to AUTO ("I") position and activate the cutting system forward for 3
seconds by inserting paper into the sensor (figure C).
-Then flip the switch to reverse for 3 seconds.
-Alternate between forward and reverse at least three times or until all paper clears
out of the cutters.
-Clean the shredder housing using a soft cloth dampened with a mild solution of
detergent (such as dish washing liquid) and warm water. DO NOT use chemical
cleaners or solvents.
TROUBLESHOOTING
SHREDDER WILL NOT OPERATE
1. Make sure shredder is plugged into power source and the main power
switch (A) is switched on.
2. Make sure the waste bin is fully inserted into the shredder housing.
PAPER JAM
1.
Press and hold REV button to clear the jam.
2.
Press power button to continue shredding.
CAUTION: Sharp cutter blades. Do not reach underneath the shredder head to
remove jammed paper. Serious injury can result.
SHREDDER STOPS WHILE SHREDDING
1.
Shredder may have reached the maximum duty cycle. Check if the red
indicator light (D) is illuminated.
2.
Switch off the main power switch (A) and unplug the shredder from the
power source.
3.
Allow the motor to cool down.
4.
Plug the shredder into power source. Switch on the main power switch (A) in
back of shredder and press the power button (B).