Drehmo c-matic Manuel d'instruction - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Drehmo c-matic. Drehmo c-matic 20 pages. Usb-adaptor kit for actuators with integrated control unit
Imprimer la page- 1. Connection on Matic C Base Plate DMC - 02 (Since Hw Rev. 5)
- 2. Connection on I-Matic Interface Unit DIM - 09 (Devicenet)
- 3. Connection on Matic C Display Unit DMC - 30 (Lcd Display Unit)
- 4. Connection on I-Matic Display Unit DIM - 02 (Ir / Irii)
- 5. Connection on I-Matic Interface Unit DIM - 17 (Modbus Loop)
3 Connectivity
3.1 SER01 adaptor
The SER01 adaptor enables the access by means of a 5 pole female reverse polarity
protected connector. By means of an integrated push button, a reset of the attached
electronic unit can be forced.
3.1.1 Connection on Matic C base plate DMC - 02 (since HW Rev. 5)
The following pictures show the position of the interface connector for the SER01 adaptor on
the DMC - 02 unit - available for hardware revision 5 or higher.
Attention:
In case of a mounted DMC - 14 unit (Profibus DP-V1 interface) the usage of this connection
is restricted. The direct serial access to the base board requires in any case the dismount of
the interface unit DMC - 14.
DREHMO
Instruction manual for USB adaptor kit
page 11 of 20