Comnet FVT110M1/BO Manuel d'installation et d'utilisation - Page 2
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Comnet FVT110M1/BO. Comnet FVT110M1/BO 4 pages. In-dome 10-bit digital video transmitter with bosch biphase and bilinx camera control
Imprimer la page
INSTALLATION AND OPERATION MANUAL
FIGURE 1 – FVT110/BO TRANSMITTER
CONNECTIONS FOR BOSCH CAMERA FIBER MODULE:
IN-DOME VIDEO TRANSMITTER MODULE (FVT110 / PCA1144):
1. Install provided accessory
2 Connect power and data
mounting kit as shown.
Secure the insert into
camera with screws.
* NOTE: Data LED D2 will flash green when Bosch Biphase data is received.
TEch SUPPORT: 1.888.678.9427
SINGLE MODE
OR MULTIMODE
OPTICAL FIBER
3. Connect video to
from the camera to the
module at J5 (8-pin male
connector with white
plastic shroud) with
Bosch's 5-pin to 8-pin
cable assembly.
Video lED D1 should
illuminate red.
Data lED D2 should stay
off*.
link lED D3 should
illuminate red.
4. Connect Single mode or
module at J4 (2-pin
Multimode fiber to U11
male connector with
(single ST fiber optic
white plastic backing)
connector).
with ComNet's 2-pin to
link lED should
BNC cable, connecting
illuminate green once
the other end to the
receiver is powered on
Dome BNC.
and link is established
Video lED D1 should
over the fiber.
illuminate green.
FVT110(M,S)1/BO
5. Attach the
FVT110/BO module to
the accessory insert with
white plastic stand-offs.
The stand-offs will snap
into the gold mounting
holes in the module as
shown.
INS_FVT110/BO_REV–
2/15/12
PAGE 2