Andis CNG-1 Manuel d'utilisation et d'entretien - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Andis CNG-1. Andis CNG-1 12 pages.

Imprimer la page
The nail grinder must be OFF before plugging the charger into the outlet. Plug the
adapter cord plug directly into the bottom of the nail grinder (Figure A). The nail
grinder has a lithium-ion battery that cannot be damaged by overcharging. We
recommend that the nail grinder be unplugged if not used for seven or more days.
NAIL GRINDER INDICATOR LIGHTS
See the chart on page 5 for charging status and corresponding indicator lights.
FAILURE TO CHARGE
1. Make sure voltage is present at the wall outlet (confirm with an appliance you know
is working).
2. Check to make sure adapter cord plug is plugged firmly into bottom of nail grinder.
If failure to charge still exists, return nail grinder to Andis or an Andis authorized
service station for examination and repair or replacement.
CORDLESS OPERATION
When the battery is fully charged, the green FULL BATTERY light will blink. When the
battery charge is low, the green FULL BATTERY light will turn off and the red CHARGE
BATTERY light will blink (Figure A).
Once the battery has fully run down (after approximately 180 minutes of use), the red
CHARGE BATTERY light will turn off, indicating that the battery should be recharged
or the nail grinder should be used with the adapter cord (Figure A).
USE WITH ADAPTER CORD
If the nail grinder powers off in the middle of a job, the adapter cord can be attached
to continue use in corded operation. When the unit is running with the adapter cord
attached, the green FULL BATTERY light will remain on and the red CHARGE
BATTERY light will blink (Figure A).
USING THE GRINDER ATTACHMENTS
Your Andis nail grinder comes with a conical grinding stone, a grinding wheel and
a multi-function protective cap (Figure A). It is recommended to use only Andis
attachments made specifically for the CNG-1 nail grinder.
The multi-function protective cap has three ports, suitable for use on small or large
size pets (Figure B). The multi-function protective cap should only be used with the
grinding wheel.
• Use Port "A" for small sized pets.
• Use Port "B" for large sized pets.
• Use Port "C" for quick nail grinding. Use your thumb and index finger to hold your
pet's paw, and touch the grinder slightly to start grinding the nail. Do not keep the
grinding stone against the nail for longer than three seconds at a time (Figure B).
To remove multi-function protective cover: Twist counterclockwise to unlock and pull
straight up (Figure C).
4
A
GRINDING
WHEEL
POWER &
TURBO
BUTTON
TURBO
SPEED
LIGHT
FULL
BATTERY
LIGHT
CHARGE
BATTERY
LIGHT
ADAPTER
CORD
NAIL GRINDER INDICATOR LIGHT STATUS
Nail Grinder in Use
Indicator Light Status
Full Charge
FULL BATTERY light blinks
Low Charge
CHARGE BATTERY light blinks
Nail Grinder Charging
Indicator Light Status
CHARGE BATTERY light on
When Charging
FULL BATTERY light blinks
CHARGE BATTERY light off
Fully Charged
FULL BATTERY light on
B
PORT "A"
GRINDING
STONE
PROTECTIVE
COVER
PORT "B"
PORT "C"
MULTI-FUNCTION
PROTECTIVE CAP
CHARGER
C
TURN
COUNTER-
CLOCKWISE
D
QUICK
45°
PULL OFF
ANGLE OF
TRIM
5