Electrolux EGG6242NOX Manuel de l'utilisateur - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Electrolux EGG6242NOX. Electrolux EGG6242NOX 20 pages. 60cm wide black gas hob with enamel pan supports.

Imprimer la page

12 www.electrolux.com

10807 standards. Be careful they do not

come in touch with mobile parts or they

are not squeezed. Also be careful when

the hob is put together with an oven.

It is important to install the elbow

correctly, with the shoulder on the

end of the thread, fitted to the hob

connecting pipe.

Failure to ensure the correct as-

sembly will cause leakage of gas.

Make sure that the gas supply

pressure of the appliance obeys

the recommended values.

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end).

8.3 Injectors replacement

Remove the pan supports.

Remove the caps and crowns of the

burner.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Techni-

cal Information" chapter).

Assemble the parts, follow the same

procedure backwards.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.4 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

Light the burner.

Turn the knob on the minimum posi-

tion.

Remove the knob.

With a thin screwdriver, adjust the by-

pass screw position.

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the ad-

justment screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn.

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.5 Electrical connection

• Do not pull the mains cable to discon-

nect the appliance. Always pull the

mains plug.

• The appliance must not be connected

with an extension cable, an adapter or

a multiple socket. There is a risk of fire.

• Do not let the power cable to heat up

to a temperature of more than 90° C.

The cable should be guided by means

of clamps fixed to the side of the cabi-

net, in order to avoid any contact with

the equipment beneath the cooktop.

• Make sure that there is access to the

mains plug after the installation.

Electrical Requirements

Permanent electrical installation must

agree with the latest I.E.E. Regulations

and local Electricity Board regulations. For

your own safety the installation must be

done by a qualified electrician (e.g. your

local Electricity Board, or a contractor

who is on the roll of the National Inspec-

tion Council for Electrical Installation Con-

tracting [NICEIC]).

The manufacturer refuses to

be held responsible, if these

safety measures are not abi-

ded by.