Electrolux EHE 688 W Livret d'instructions - Page 15

Parcourez en ligne ou téléchargez le pdf Livret d'instructions pour {nom_de_la_catégorie} Electrolux EHE 688 W. Electrolux EHE 688 W 16 pages. Electric hob
Également pour Electrolux EHE 688 W : Livret d'instructions (16 pages), Livret d'instructions (16 pages)

Imprimer la page

Electrical connections

Any electrical work required to install this

hob should be carried out by a qualified

electrician or competent person, in

accordance with the current regulations.

THIS HOB MUST BE EARTHED.

The manufacturer declines any liability

should these safety measures not be

observed.

This hob is designed to be connected to a

230-240V 50Hz AC electrical supply.

Before switching on, make sure the electricity supply

voltage is the same as that indicated on the hob rating

plate. The rating plate is located on the bottom of the

hob. A copy is attached on the back cover of this

book.

The hob is supplied without supply cord. A 3 core

flexible supply cord must be fitted, in accordance

with the specification given in the relevant tables.

1) Remove the mains terminal cover plate from

the underside of the hob, to expose the mains

terminal block.

2) Loosen the two cable clamp screws and lift

the top section of the clamp enough to allow

the cable to be passed through.

3) Connect the red (live) wire to the terminal

which is marked with the number 1.

4) Connect the black (neutral) wire to the

terminal which is marked with the number 4.

5) After fitting a green or yellow/green sleeve

over the bare copper wire (earth wire), connect

the exposed end to the terminal which is

marked with the earth symbol

number 5.

NOTE:

The earth wire should be about 2 cm. longer

than the live and neutral wires.

6) Secure the cable by means of the clamp screws

and refit the terminal block cover.

The hob should be conncted to a double pole switch

with a minimum gap of 3 mm. between the switch

contacts and of a type suitable for the required load in

compliance with the current electric regulations. The

switch should be sited within 2m of the hob and be

easily accessible upon completion of the installation.

The switch must not break the yellow and green earth

cable at any point.

Supply Cable Specifications

For Uk use only

Connection

via

• Cooker

Control

Circuit

For Europe use only

Min. size Cable/flex

2.5 mm

or with the

Ensure that the hob supply cord does not

come into contact with surfaces with

temperatures higher than 50 deg. C.

Min. size

Cable / flex Fuse

Cable/flex

type

6 mm

PVC/PVC

twin and

earth

Cable / flex type

H05 RR-F

FO 0488

30 A

Fuse

30 A