Compac ComTank Fiche d'installation - Page 11

Parcourez en ligne ou téléchargez le pdf Fiche d'installation pour {nom_de_la_catégorie} Compac ComTank. Compac ComTank 18 pages.

Electrical Connection

Cable requirements

230V Mains

Pump Comms

Nozzle switches

Tank Gauging (option)

Compac Industries Ltd.

ComTank control unit power: 3 Core Steel Wire Armour Cable 2.5mm

10A, 50 Hz

Pump comms (standard current loop): 2 core Steel Wire Armour (SWA).

Pump comms (RS485): 3 core Steel Wire Armour (SWA).

Refer to the wiring diagram on page 12. Connect the incoming mains as follows:

All terminals marked "N" are common.

All terminals marked "P" are common.

Connect the Earth to the busbar at the bottom of the cabinet.

Connect the pump comms cable(s) to the terminals on the DIN rail.

If pumps do not communicate on start up, swap the wires over.

The nozzle switch cable is pre-wired to the pump. Plug into the socket(s) on the

nozzle switch(es) making sure the correct cable is connected to the nozzle.. Coil

and neatly cable tie any excess cable out of the way.

Tank gauging if fitted should be wired to the Tx, Rx and G terminals. If tank level

does not appear on your administration program after initial setup swap the Tx and

Rx wires.

All wires entering the unit should be glanded and secured to prevent

stressing the terminals.

Page 11

. 230 Volts,