Dremel 2200 Versaflame Manuel d'utilisation et de sécurité - Page 7
Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et de sécurité pour {nom_de_la_catégorie} Dremel 2200 Versaflame. Dremel 2200 Versaflame 10 pages.
Imprimer la page
Find Quality Products Online at:
Lighting and operation of the
Dremel VersaFlame
The Dremel VersaFlame is equipped with a
safety mechanism intended to protect against
unintended ignition.
To ignite the torch:
a. Open the Air Control Knob by aligning it as
shown in Figure 6.
b. Turn the Flame Control Slider to the
minimum position as shown in Figure 7.
c. Grasp the torch body placing your thumb
on the Safety Lock. Using your thumb, pull
down
on
the
Safety
simultaneously rotating the Safety Lock in
a clockwise direction until it clicks into
place on the left side of the tool as shown
in Figure 8.
d. Slowly depress the Ignition Button until the
torch ignites as shown in Figure 9.
e. Observe the Burner for the presence of the
flame, or if using the Flame Diffuser,
observe the Flame Diffuser to see if glow
of the flame is visible. Also, listen for a
sound of torch flame.
If there is no flame glow and the sound is
of the escaping gas, then release the
Ignition Button and repeat steps c and d.
If ignition occurs, continue to step f.
f. If using the Flame Diffuser immediately
after initial torch ignition, close the Air
Control Knob for 2 seconds then
immediately return it to its original position
as shown in Figure 10.
GlobalTestSupply
www.
FIG. 6
Lock
while
FIG. 7
FIG. 9
-7-
FIG. 8
FIG. 10
.com