Compact Light System DMX16 Manuel de l'utilisateur - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Compact Light System DMX16. Compact Light System DMX16 8 pages. 16 channels dmx light mixer

Imprimer la page

Getting Started

Connect all the DMX units together with the DMX Cables.

Set the respectively DMX addresses on each unit connected to the

CLS DMX16. (See the instruction manual for each units.) Plug in a terminator

at the last unit of the DMX line. (XLR contact with a 120 Ohms resistor connected

between pin 2 and 3.)

Connect the power for every unit and the CLS DMX16 Mixing Console.

You are now ready to make your first show with CLS DMX16.

Selecting the CLS DMX16 Easy Mode or Advance Mode:

Press and Hold the Flash button 1 and the Functions knob 4.

While holding these: Connect the power.

This will Switch between the Easy Mode and Advanced Mode.

To check what Mode you are in: Push a Function knob in the front of the CLS

DMX16. The led will light. Do it again and the led will go out. This means that the

CLS DMX16 is in Easy Mode.

Easy Mode:

In Easy Mode the CLS DMX16 has disabled many of the functions

to make it easier for non experience users. The is NO Chaser, Crossfade, Blackout,

Flash or Smoke knob ch.17. available. The Group select is made easier and Store the

scenes is just to hold down the Flash knob for 5 sek.

Programming the CLS DMX16 - Easy Mode.

1. The first you see when you connect the power is a light in the first led. This tells

you that the CLS DMX16 is in Mix Mode, Group 1 is activated and the faders will

work at DMX Ch. 1-4. Mix the lights the way you want them, change Group by

pressing a function knob, the Leds on selected groups will light up. It is possible to

select more than 1 group, up to 4, at the same time.

2. Mix more and so on...

3. Save the scene by pressing and holding a flash knob until the leds is flashing.

(5sek)

4. Mix more...

5. Save the scene to another flash knob and so on.

6. Select the saved scenes by pressing a flash knob.

When selecting a scene on a Flash knob, the Group select will reset to no Group

selected. The led(s) will stop lighting. To mix manually you have to select one Group

or more with the functions knobs to get the faders working.

If you change to Advanced Mode, the CLS DMX16 will remember the scenes from

the Easy Mode and vice versa.