dresden elektronik RaspBee II Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} dresden elektronik RaspBee II. dresden elektronik RaspBee II 8 pages. Zigbee usb gateway
Imprimer la page
Radio certification
United States (FCC)
FCC ID: XVV-RASPBEE2
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
o
Reorient or relocate the receiving antenna.
o
Increase the separation between the equipment and receiver.
o
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
o
Consult the dealer or an experienced radio/TV technician for help.
Modifications not expressly approved by this company could void the user's authority to operate this
equipment (FCC section 15.21).
Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
List of applicable FCC / ISED rules
FCC: 47CFR Part 15C
ISED: RSS-247
Specific operational use conditions
The module is designed to be used on Raspberry Pi Single board computer. The OEM integrator has
to follow all rules stated in this manual. Since this is a limited module some restrictions stated in
following section apply.
If a firmware different from firmware delivered by module manufacturer is used, Transmit power
registers need to be configured 0x0C for Channel 1-25 and 0x0F for channel 26.
Limited module procedures
Due to the fact that this RF Module is not equipped with an own shielding, the end-product incl. this
RF Module has to show compliance to the FCC rules (15C / radiated emissions).
(OEM) Integrator has to assure compliance of the entire end-product incl. the integrated RF Module.
Additional measurements (15C) and/or equipment authorizations (e.g either a complete new
certification or a Class II Permissive Change) may need to be addressed depending on co-location or
simultaneous transmission issues if applicable.
In the event that these conditions cannot be met, or when installing this module in another host as
tested in this FCC filing, then the FCC authorization for this module in combination with the host
equipment is no longer considered valid and the FCC ID of the module cannot be used on the final
product. In these circumstances, the OEM integrator will be responsible for re-evaluating the end
product (including the transmitter) and obtaining a separate FCC authorization.
Trace antenna designs
not applicable, the RF part is fully integrated on the module.
dresden elektronik ingenieurtechnik gmbh
Enno-Heidebroek-Str. 12
01237 Dresden | Germany
© 2019 dresden elektronik ingenieurtechnik gmbh. Alle Rechte vorbehalten. Alle Warenzeichen, eingetragene Warenzeichen
und Produktnamen sind das Eigentum der jeweils Berechtigten. Für die Aktualität, Vollständigkeit und Richtigkeit der
enthaltenen Informationen können wir keine Garantie übernehmen. Technische Änderungen vorbehalten.
Tel: +49 351 31850-0 Fax: -10
www.dresden-elektronik.de
Kontakt