Andrew CommScope Metro Cell Series Instructions d'installation - Page 2

Parcourez en ligne ou téléchargez le pdf Instructions d'installation pour {nom_de_la_catégorie} Andrew CommScope Metro Cell Series. Andrew CommScope Metro Cell Series 2 pages.

Imprimer la page
Metro Cell Family Antennas Installation Instruction
(Continued from page 1)
Notice:
Before mounting the base plate to the mounting surface,
position the antenna unit so that the boresite indicator on
each antenna is directed where boresite is desired.
Radome
Connection
Fastener
(Do not
remove.)
Mounting kit
support base
must include
openingsto
allow routing
of RF cables
(not supplied
with antenna.)
Figure 3. Determining Boresite for Each Antenna.
Use inclinometer
to verify antenna
is truly vertical.
Mounting Kit
Support Base
(not supplied
with antenna)
Figure 5. Routing RF Cable and Vertical Alignment
CommScope
1100 CommScope Place SE P.O. Box 339, Hickory, NC 28603-0339
(828) 324-2200 (800) 982-1708
www.commscope.com/andrew
Notice: CommScope disclaims any liability or responsibility for the results of improper or unsafe installation, inspection, maintenance, or removal practices.
Aviso: CommScope no acepta ninguna obligación ni responsabilidad como resultado de prácticas incorrectas o peligrosas de instalación, inspección, mantenimiento o retiro.
Avis : CommScope décline toute responsabilité pour les conséquences de procédures d'installation, d'inspection, d'entretien ou de retrait incorrectes ou dangereuses.
Hinweis: CommScope lehnt jede Haftung oder Verantwortung für Schäden ab, die aufgrund unsachgemäßer Installation, Überprüfung, Wartung oder Demontage auftreten.
Atenção: A CommScope abdica do direito de toda responsabilidade pelos resultados de práticas inadequadas e sem segurança de instalação, inspeção, manutenção ou remoção.
Avvertenza: CommScope declina eventuali responsabilità derivanti dell'esecuzione di procedure di installazione, ispezione, manutenzione e smontaggio improprie o poco sicure.
注意：CommScope 公司申明对于不恰当或不安全的安装、检验、维修或拆卸 操作所导致的后果不负任何义务和责任。
@2015 CommScope Bulletin 639843
Bulletin 639843 • Revision A • AUGUST 2015 • Page 2 of 2
Boresite
Indicator
Radome
Connection
Fastener
(Do not
remove.)
Notice:
Torque hardware to 100 Nm (880 lbf-in), hardware not
supplied with antenna.
1. Refer to Figures 2, 3 and 4 for mounting and bore-
site alignment. It is recommended that the mounting
holes be marked and made ready in the mounting
surface prior to installing the antenna.
2. Attach the RF cable to the antenna GPS connector
firstly, and then attach the RF cables to the antenna
input connectors, and the 4.3/10.0 DIN connectors to
5-10 Nm (44-88 lbf-in), refer to Figure 5.
Figure 4. Antenna Installation Interface
Customer Service 24 hours
North America: +1-800-255-1479 (toll free)
Any country: +1-779-435-6500
Locting Nut
Flat Washer
M24 Bolt