ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in
WARNING
the vicinity of this or any other appliance.
Cooktop Dimensions
30" Min. *
(76.2 cm)
A
D
F
Cooktop Cutout
Dimensions
H
* 30" (76.2 cm) min. for unprotected cabinet
24" (61 cm) min. for protected surface
MODEL
30" Model
36" Model
MODEL
30" Model
36" Model
All dimensions are in inches (cm).
* Allow 2" (5 cm) space below cooktop to clear the electric cable and allow for installation of the junction box on the
wall at the back of the cooktop.
Printed in United States
IMPORTANT INSTALLATION INFORMATION
• All electric cooktops run off a single phase, three-wire or four-wire
cable, 240/208 volt, 60 hertz, AC only electrical supply with ground.
• Minimum distance between cooktop and overhead cabinetry is 30"
(76.2 cm).
B
C
E
I
PRODUCT DIMENSIONS
A. WIDTH
B. DEPTH
30¾ (78.1)
21¾ (55.2)
36¾ (93.3)
21¾ (55.2)
G. WIDTH
MINIMUM
MAXIMUM
29¾ (75.6)
30 (76.2)
36 (91.4)
36¼ (92.1)
IMPORTANT: If a plywood is present in the cabinet under
the cooktop, install the deflector supplied under the burner box
(see Fig.1-A) as shown in fig. 1-B and make a 4" X 8" (10.2 cm
x 20.3 cm) opening to route armored cable. Note: Remove the
deflector if the cooktop is installed over a wall oven.
G
Figure 1
C.
HEIGHT
D.
2¾ (7)
6½ (16.5)
2¾ (7)
6½ (16.5)
CUT OUT DIMENSIONS
H. DEPTH
MINIMUM
20
3
/
(51.8)
8
20
3
/
(51.8)
8
English – pages 1-5; Español – pages 6-10; Français - pages 11-15; Notes - 16
1
Deflector shipping
position
Figure 1-A
Deflector position when a
plywood is present in
the cabinet
Figure 1-B
E. BOX WIDTH
F. BOX DEPTH
28½ (72.4)
19
1
/
(48.4)
16
34
5
/
(87.9)
19
1
/
(48.4)
8
16
I. HEIGHT BELOW
MAXIMUM
COOKTOP*
20½ (52.1)
8½ (21.6)
20½ (52.1)
8½ (21.6)
P/N 318201445 (0705) Rev. A
Imprimer la page