Electrolux 922728 Manuel d'installation - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} Electrolux 922728. Electrolux 922728 28 pages. Built-in hood for electric and gas oven
Imprimer la page•
Do not use products (even if diluted) containing chlorine (sodium hypochlorite, hydrochloric
or muriatic acid, etc.) to clean the appliance or the floor under it.
•
Do not spray water or use water jets or steam to clean the equipment.
•
Do not store or use petrol or other flammable substances in the vicinity of this or any other
appliance.
•
Do not spray aerosols in the vicinity of this appliance while it is in operation.
•
Never check for leaks with a naked flame.
Transport, handling and storage
A.4
Protection devices installed on the machine
•
Due to their size, the machines can be stacked on top of each other during transport,
handling and storage by complying with that specified on the slip placed on the packaging.
•
Do not stand under suspended loads during loading/unloading operations. Unauthorised
personnel must not enter the work area.
•
The weight of the appliance alone is not sufficient to keep it steady.
•
For machine lifting and anchoring, do not use movable or weak parts such as: casing,
electrical raceways, pneumatic parts, etc.
•
Do not push or pull the appliance to move it, as it may tip over.
•
Machine transport, handling and storage personnel must be adequately instructed and
trained regarding the use of lifting systems and personal protective equipment suitable for
the type of operation carried out (e.g. overalls, safety shoes, gloves and helmet).
•
When removing the anchoring systems, make sure the stability of the machine parts does
not depend on the anchoring and, therefore, that this operation does not cause the load to
fall off the vehicle. Before unloading the machine components, make sure all the anchoring
systems are removed.
•
Machine positioning, installation and disassembly must be carried out by specialised
personnel.
Installation and assembly
A.5
•
The operations described must be carried out in compliance with the current safety
regulations, regarding the equipment used and the operating procedures.
•
The plug (if present) must be accessible after positioning the appliance in the place of
installation.
•
Disconnect the appliance from the power supply before carrying out any installation
procedure.
Electrical connection
Before connecting, make sure the mains voltage and frequency match that indicated on
the appliance data plate.
•
Work on the electrical systems must only be carried out by specialised personnel.
•
Connection to the power supply must be carried out in compliance with the regulations and
provisions in force in the country of use; devices for disconnection from the mains must be
incorporated in the fixed wiring in accordance with the wiring regulations.
•
The information regarding the appliance power supply voltage is given on the data plate.
•
The system power supply is arranged and able to take the actual current absorption and is
correctly executed according to the regulations in force in the country of use.
9