Electrolux DF7290 Manuel d'installation et d'utilisation - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Electrolux DF7290. Electrolux DF7290 9 pages. Built-in- flat-screen fume extractor hood

Imprimer la page

INSTALLATION

• The Hood can be fitted directly on the

lower surface of the Wall Units (650 mm

min. above the Cooker Top) using the snap-

on Side Supports.

• Make an opening on the lower surface of

the Wall Unit, as indicated. (fig.1)

• If the cabinet is without bottom, fix the two

brackets at a distance B of minimum 30mm

and maximum 60mm. (fig.2)

• Before carrying out the installation, the

wooden transportation protections screwed

on the visor and on the canopy body must

be removed. (fig.3)

• Choose the correct flange measure basing

on the air outlet diameter and insert it to the

upper air outlet opening. (fig.4)

• Screw the closing profile 20 onto the rear

part of the hood, using the screws 12f (2.9

x 9.5) provided. (fig.5)

• Open the sliding suction panel.

• Remove the metal grease filters one by one

by turning the hooks provided.

• Close the sliding suction panel again.

• Insert the Hood until the snap-on side sup-

ports click into place. (fig.6)

• Open the sliding suction panel.

• Lock in position by tightening the screws

Vf from underneath the Hood. (fig.6)

• If necessary, adjust the whole filter holder

unit and proceed as follows:

• Loosen the four adjustment screws Vr

and close the sliding panel again. (fig.7)

• Move the entire filter holder unit until it

is properly aligned with the wall unit.

(fig.8)

• Keeping the hood canopy still, remove

the sliding panel and lock the adjustment

screws again. (fig.7)

• The hood can now be fastened to the

wall unit using the four screws 12a (3.5

x 16) provided. (fig.9)

• Replace the metal grease filters.

• Close the sliding suction panel again.

Drilling the Support surface and Fitting the Hood

162

523

12a

10b

10a

1 16