Electrolux DVK6010WE Manuel d'instruction - Page 30

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Electrolux DVK6010WE. Electrolux DVK6010WE 36 pages.
Également pour Electrolux DVK6010WE : Manuel d'instruction (36 pages)

Imprimer la page

Electrolux DVK6010WE Manuel d'instruction

3. INSTALLATION

3 - INSTALLATION

3.1 - Fitting the splashback

Before installing the hood it is possible to fit the splash-

back provided, if required.

• Mark the holes required to fix it to the wall, as shown

in fig. A.

• Drill the wall (2 holes Ø 5mm) and insert the wall

plugs.

• Fix the splashback to the wall using the two 3x35

screws (provided).

3.2 - Wall installation

The hood can be supplied with two different fixing kits:

a) screws, plugs and safety square.

b) screws, plugs and metal brackets.

1 - Fixing with screws

Using the cardboard template, mark and drill the holes

on the wall (2 holes Ø 8 mm see instructions on the

template), insert the plugs in the holes, tighten both

4,2 x 44,4 screws(supplied) leaving about 5 mm un-

screwed, hook the hood onto the screws (fig. 1) and

secure tightly from inside (fig. 2). Mount the safety

square (supplied) above the hood (fig. 3).

3.3 – Wall unit installation

Using the cardboard template, mark and drill the

bottom of the wall unit, (see instructions on the tem-

plate).

Fasten the hood from inside the unit using four screws

4,2 x 44,4 (supplied) (fig.7). For suction hoods, the

wall unit must be drilled to allow for the air discharge

duct. Filter hoods do not require this type of drilling

operation since the air is recycled into the room

through vents situated on the front of the hood.