Electrolux ECI6300S Manuel de l'utilisateur - Page 6
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Electrolux ECI6300S. Electrolux ECI6300S 28 pages.
Imprimer la page
www.electrolux.com
6
4. CONTROLS
Button
A
B
C
D
E
F
G
H
Function
Turns the suction motor on and off at speed one.
Decreases the working speed.
Increases the working speed.
Activates Intensive speed from any other speed,
including motor off. This speed is set to operate for 6
minutes, after which the system returns to the speed
that was set before. Suitable to deal with maximum
levels of cooking fumes.
Press and hold the button for approximately 5 seconds,
with all the loads turned off (Motor and Lights), to
turn the Activated Charcoal Filter alarm on/off.
24H function
Turns the motor on at speed one and effects one 10
minute extraction every hour.
When the filters alarm is triggered, the alarm can
be reset by pressing and holding this button for
approximately 3 seconds. These indications are only
visible when the motor is turned off.
Delay function
Activate automatic switch-off with a 30' delay.
Suitable to complete elimination of residual odours. It
can be activated from any position and is deactivated
by pressing the button or turning the motor off.
This mode does not function if Intensive or 24h is
active.
Turns the lighting system on and off at maximum
intensity.
Turns the lighting system on and off in Courtesy Light
mode.
Display
Displays the set speed
Displays the set speed
Displays the set speed
Displays HI and the time remaining once
every second.
FC+Dot (2 flashes)–Alarm On.
FC+Dot (1 flash)–Alarm Off.
Displays 24 and the dot at the bottom right
flashes once a second, while the motor
is running. It is disabled by pressing the
button.
FF flashes three times.
When the procedure terminates, the
indication shown previously turns off:
FG indicates the need to wash the metal
grease filters. The alarm is triggered after
the Hood has been in operation for 100
working hours.
FC indicates the need to change the
activated charcoal filters, and also to
wash the metal grease filters. The alarm
is triggered after the Hood has been in
operation for 200 working hours.
Displays the operating speed and the dot at
the bottom right flashes once a second.