Accueil
Marques
Bosch
Réfrigérateur
Bosch 6 Series
Manuel d'instructions pour l'installation et l'utilisation
Page 10

Bosch 6 Series Manuel d'instructions pour l'installation et l'utilisation - Page 10

Imprimer la page

Bosch 6 Series Manuel d'instructions pour l'installation et l'utilisation

Cleaning and maintenance

Lighting

The lighting can be switched on and off independently

of the fan.

Touch the

symbol.

Setting the brightness

Press and hold the

symbol until the required

brightness is reached.

Saturation display

If the metal grease filters or the activated charcoal filter

are/is saturated, the corresponding symbols flashes

after the appliance is switched off:

Metal grease filters:

■

Activated charcoal filter:

■

Metal grease filters and activated charcoal filter:

■

and

If you have not yet done so, the metal grease filters

should now be cleaned or the activated charcoal filter

replaced. ~ "Cleaning and maintenance" on page 10

The saturation indicator does not apply for non-

Note:

renewable activated charcoal filters that are inserted

downstream of the metal grease filter. These activated

charcoal filters must be replaced twice a year.

The saturation indicators can be reset while they are

flashing. To do this, touch the appropriate symbol.

Switching over the display for air recirculation mode

For air recirculation mode, the electronic controller must

be switched over accordingly:

The extractor hood must be connected and switched

■

off.

Touch and hold the

■

symbol.Take your finger off the

will switch the electronic controller over to air

recirculation mode (filters that cannot be

regenerated).

Touch and hold the

■

symbol.Take your finger off the

will switch the electronic controller over to air

recirculation mode (filters that can be regenerated).

Repeatedly touching and holding the

■

and touching the "1" symbol switches the electronic

controller back over to air extraction mode.

Audible signal

Switching on

Touch and hold the

time for approximately 3 seconds when the fan is

switched off. An audible signal will sound as an

acknowledgement.

Switching off

Touch and hold the

time for approximately 3 seconds when the fan is

switched off. An audible signal will sound as an

acknowledgement.

symbol. Touch the "2"

symbol. This

symbol. Touch the "3"

symbol. This

and

symbols at the same

and

symbols at the same

2Cleaning and maintenance

Warning – Risk of burns!

C l e a n i n g a n d m a i n t e n a n c e

The appliance becomes hot during operation. Allow the

appliance to cool down before cleaning.

Warning

Risk of electric shock!

Penetrating moisture may result in an electric shock.

■

Clean the appliance using a damp cloth only. Before

cleaning, pull out the mains plug or switch off the

circuit breaker in the fuse box.

Do not use any high-pressure cleaners or steam

Risk of electric shock!

■

cleaners, which can result in an electric shock.

Warning – Risk of injury!

Components inside the appliance may have sharp

edges. Wear protective gloves.

Caution!

There is a risk of surface damage if you do not peel off

the protective film.Remove the protective film from all

parts of the appliance before using the appliance for the

first time.

Cleaning agents

To ensure that the different surfaces are not damaged

by using the wrong cleaning product, follow the

instructions in the table. Do not use any of the following:

Harsh or abrasive cleaning agents, e.g. scouring

■

powder or liquid scouring cleaner,

Cleaning products with a high alcohol content,

■

Hard scouring pads or cleaning sponges,

■

Pressure washers or steam cleaners,

■

Cleaning products that dissolve limescale,

■

Aggressive all-purpose cleaning products,

■

Oven spray.

■

Wash new sponge cloths thoroughly before use.

Note:

Follow all instructions and warnings included with

Note:

the cleaning products.

symbol