Bosch 6 Series Manuel d'instructions pour l'installation et l'utilisation - Page 15

Attaching and aligning the appliance

First, remove the protective foil from the back of the

appliance and, following installation, remove the foil

completely.

When attaching the appliance, ensure that it

engages firmly with the brackets.

Align the appliance horizontally by turning the

brackets. If required, the appliance can be moved to

the right or left.

Firmly tighten the screws for the brackets. When

doing so, hold the brackets securely in place.

Firmly tighten the knurled nuts.

Connecting the pipes

Note:

If using an aluminium pipe, smooth the

connection area beforehand.

Exhaust-air pipe Ø 150 mm (recommended size)

Attach the exhaust-air pipe directly to the air-pipe

connector and seal.

Exhaust-air pipe Ø 120 mm

Attach the reducing connector directly to the air-pipe

connector.

Attach the exhaust air pipe to the reducing

connector.

Seal both joints appropriately.

Attaching the flue duct

Warning – Risk of injury!

Components inside the appliance may have sharp

edges. Wear protective gloves.

Separate the flue ducts.

To do this, remove the adhesive tape.

Remove the protective foil from both flue ducts.

Push one flue duct into the other.

Notes

– To prevent scratches, lay paper over the edges of

the lower flue duct to protect the surface.

– Slots of the inner flue duct point downwards.

Place flue ducts on the appliance.

Push the inner flue duct upwards and attach it to the

fixing brackets on the left and right.

Press the flue duct downwards until it engages.

Screw the flue duct to the sides of the fixing bracket

using two screws.

Installation