Advanced Native Technologies ING 30 Manuel de l'utilisateur - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Advanced Native Technologies ING 30. Advanced Native Technologies ING 30 15 pages. Ing series uhf in ear monitor systems sistemi in ear monitor uhf

Imprimer la page

3 | SYSTEM SETuP

For optimal transmission, the transmitter height must be at least 1 m (3ft) and put the

antenna vertically, upward. Avoid placing the transmitter close to metal objects or to

digital devices (CD players, computers, console, and so on).

The transmitter and receiver must be placed to have a straight "visual contact".

3.1 | TRANSMITTER SETuP

The main screen of the display shows radio frequency, the selected operating mode

(MONO/STEREO), the transmission level of the AF1 and AF2 signals and the lock, if

it's activated.

1 GROuP SELECTION

Press the SET button until when "GROUP" appears in the display.

Use the up and down buttons to select the desired group of frequency, then press

again SET to confirm the choice.

2 CHANNEL SELECTION

Press the SET button until when "CHANNEL" appears in the display.

Use the up and down buttons to select the desired channel, then press again SET

to confirm the choice. Simultaneously using more systems, it's better to have them

on the same group but on different channels.

3 STEREO OR MONO OPERATING MODE (ING 30T only)

Press the SET button until when "STEREO" or "MONO appears in the display. Use the

up and down buttons to select the desired mode, then press again SET to confirm

the choice. In Mono mode you will listen to AF2 signal, while in STEREO you listen

to both AF1 and AF2 signals.

ATTENTION: for ING 20T the selection for MONO/STEREO mode is mechanically

achieved by a switch on transmitter rear panel.

4 LOCK ACTIVATION AND DEACTIVATION

Press the SET button until when the icon "LOCK" start flashing in the display, then

ING Series

User manual |

Series

press the up and down buttons to confirm the choice.

To deactivate LOCK and edit the settings, you need to press the button

"SET" for 2 seconds.

ATTENTION: when LOCK icon is displayed, you can see the unit settings,

but these settings are not editable.

3.2 | BELTPACK RECEIVER SETuP

The main screen of the display shows radio frequency, the selected operating

mode (MONO/STEREO), the transmission level of the AF1 and AF2 signals,

batteries status, and the lock, if it's activated. ING 30R display shows also

information about TONE, LIMITER, and MIX features.

To do your settings, use the SET button and the up and down buttons. In ING

30R there is also an ESC button, useful to immediately go back to main menu.

Press on the sides of the lid to lift the lid, and to access to the hidden buttons:

ESC and SET (ING 30R) o up and down (ING 20R).

1 AF1 AND AF2 CHANNELS VOLuME BALANCE (ING 30T only)

Press the up/down buttons to adjust volume balance between AF1 and

AF2 of a Stereo signal If the transmitter is in Mono mode, using the up/

down buttons you set the position of the signal in the Stereo field.

2 GROuP SELECTION

Press the SET button for 2 seconds until when "GROUP" starts flashing in

the display. Use the up and down buttons to select the desired frequency

group, then press again ESC (ING 30R) or SET (ING 20R) to exit the menu.

3 CHANNEL SELECTION

Press the SET button for 2 seconds to access the settings menu, then

press again SET until when "CHANNEL" starts flashing in the display.

Use the up and down buttons to select the desired frequency group, then

ING Series

| User manual