Atlantic TidalWave FP100 Series Manuel d'utilisation - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Atlantic TidalWave FP100 Series. Atlantic TidalWave FP100 Series 4 pages.

Imprimer la page

Troubleshooting Guide

Always turn off power before inspecting the pump. Failure to observe this precaution can

result in a serious accident.

Before ordering repairs, carefully read through this instruction booklet. If the problem

persists, contact your dealer.

Problem

Possible Cause

Power is off

Power failure

Pump does

not run

Power cord is not

connected

Impeller is stuck

Pump is

overheating

Power/Current

Pump stops after

overload

starting

Intake is blocked/

Impeller needs cleaned

Obstruction in pump

or piping

Diminished

flow rate or

no water flow

Low water level

Air-lock in the

impeller chamber

1-877-80-PONDS

www.atlanticwatergardens.com

Possible Solution

Turn power on

Check power supply or

contact local power company

Connect power cord

Remove debirs/clean impeller

Submerge pump/Raise water level/

Allow pump to cool/Clean impeller

Check length/size of power cable.

Check or replace GFI

Remove debris from the pump

intake. Refer to page 5 for

cleaning instructions.

Refer to page 5 for cleaning instructions

Clear obstruction

Stop operation/Raise water level

Place pump in water. Turn the pump

ON/OFF intermittently 2 or 3 times.

rev. 3/12