2 Save Energy Owl Intuition-PV Pour commencer - Page 3

Parcourez en ligne ou téléchargez le pdf Pour commencer pour {nom_de_la_catégorie} 2 Save Energy Owl Intuition-PV. 2 Save Energy Owl Intuition-PV 12 pages. Electricity consumption & solar pv generation monitoring - single phase, for homes fitted with solar pv

Imprimer la page

STEP THREE - Pair Transmitter to the Network OWL

•

Ensure the Transmitter is next to the Network

OWL.

•

Press the small "Check" button in the Transmitter

battery compartment until the red LED on the

front starts flashing.

•

The Transmitter is now in Check Mode and the

red LED on the front will start flashing every 2

seconds (for 30 seconds).

•

The pairing process will now take place and the

blue LED will start flashing a fraction of a second

after the red LED flashes.

•

When the Transmitter Check Mode finishes, if the

pairing was successful, the blue LED will flash

every time it receives data from the Transmitter

(every 12 to 60 seconds).

•

Replace battery compartment cover.

IMPORTANT Pairing Notes & Network OWL Factory Reset:

•

If you don't complete the pairing process within 60 seconds of the

Network OWL blue LED starting its steady flash, restart the process by

removing and re-inserting the DC power jack.

•

You can quickly check for correct pairing at any time by pressing the

Transmitter "Check" button until the red LED starts flashing - if the

Transmitter red LED and Network OWL blue LED flash together they are

correctly paired.

•

If you remove / change the Transmitter batteries you will need to remove

the existing pairing from the Network OWL and pair the Transmitter again.

To clear ALL pairings in the Network OWL including other paired devices

such as heating controls, carry out a full Factory Reset as follows:

•

Factory Reset the Network OWL by pressing the reset button

while the power is on. Carefully insert a paperclip into the small

RESET

BUTTON

hole and hold the button pressed for a minimum of 10

seconds and release. The green LED will flash rapidly.

After about 30 seconds the blue LED will start a

steady flash indicating that it is in Pairing

Mode. After each Factory Reset you

must go through Step Seven,

the Web Dashboard "Create

Account" process again, but

ticking "Account Exists".

PLUG IN ETHERNET CABLE

PART NO. CMR180i

MADE IN CHINA

PRESS

CHECK BUTTON