Drieaz F571-110V Manuel du propriétaire - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Drieaz F571-110V. Drieaz F571-110V 9 pages. Cube dehumidifier

Imprimer la page

Before each use

Inspect the electrical cord for damage. Look for

fraying, cuts, etc. Replace the cord if you find any

damage.

Inspect and replace filter. Replace filter when visibly

dirty.

Monthly

Inspect coils. Clean when dust accumulation is visible.

In normal use, dust can accumulate and can restrict

airflow, reducing performance and causing the unit to

overheat. Use a vacuum cleaner with a brush tool and a

soft cloth to remove any debris. Take care not to

damage any interior components.

To maintain appearance, wipe interior and exterior

surfaces with a damp cloth. For deep cleaning and a

PUMP PURGE BUTTON

The Control Panel will display the following message when the Pump Purge Button is pressed:

C O N T R O L P A N E L

M E S S A G E

—

PUMP PURGING XX

SYSTEM MESSAGES

The Control Panel will display the following messages based on system performance and environmental conditions. User

action, if any is required, is indicated in the third column.

C O N T R O L P A N E L

M E S S A G E

INITIALIZING

FIRMWARE VERSION

XXX

FXXX-XXX

OFF

PLEASE WAIT

COMP. DELAY XX

UNIT ON XXXX HRS

INLET XXX°F / XX%

HUMIDISTAT

INLET XXX°F / XX%

HI TEMP CYCLE

REMAINING XX MIN

---

DEFROST XX

WAIT FOR

DEFROST XXX

WAIT FOR

UNIT DRYING XXX

07-02282A F571-230V & F571-110V

Pump is purging with countdown in seconds. Press key again to stop if needed.

E X P L A N A T I O N

Unit is powering up.

Indicates control board firmware version number.

Model number.

Unit has finished powering up and is operating.

60s delay before compressor turns on. Allows system

pressure to equalize.

First line: indicates total operating hours.

Second line: Toggles between inlet temperature and

inlet RH every 2 seconds.

First line: indicates unit is in humidistat mode

Second line: Toggles between inlet temperature and

inlet RH every 2 seconds.

Unit overload limit reached. Cool-down initiated.

Unit is defrosting, with countdown in seconds.

Unit turned off when coil is cold or already in a defrost

cycle. Proceeds to finish cycle or initiate one to clear the

coils of ice before storage.

Occurs when unit is turned off and coil is not frozen.

Clears the coils of water before storage.

lasting, protective shine, use an automotive interior

cleaner.

As Needed

Clean pump check valve and basin. If the unit displays

the message "ER9 PUMP BLOCKED PUMP & HOSE",

the pump check valve and pump basin may need to be

cleaned. Remove grills and cover as shown in Fig. B.

Remove screws from pump base and lift out pump. Wipe

out pump basin with a damp cloth. Unthread barbed

fitting with check valve and rinse fitting and check valve

with clean water. Reinstall barbed fitting into pump. Do

not overtighten. Reinstall pump on base. Reinstall cover

and grills. Clean coils. With the cover removed, inspect

both coils. If excessive dust and debris is present,

vacuum thoroughly and/or clean with coil cleaner.

E X P L A N A T I O N

U S E R A C T I O N

None

Legend Brands Europe Holdings Ltd.