Electrolux REX CA 962 ALU Manuel - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Electrolux REX CA 962 ALU. Electrolux REX CA 962 ALU 15 pages.

Part 1 - INSTALLATION INSTRUCTIONS

3.8 - Before carring out any kind of maintenance or cleaning, disconnect the hood from the

mains supply.

3.9 - If the room where the cooker hood is to be used contains a fuel burning appliance such

as a central heating boiler then this must be of the room sealed or balanced flue type.

If other types of flue or appliance are fitted ensure that there is an adequate supply of

air into the room. When the cooker hood is used in conjunction with other appliances

supplied with energy other than electric, the negative pressure in the room

must not exceed 0,04 mbar to prevent fumes being drawn back into the room by the

cooker hood.

4 - INSTALLATION

The versatility of the ducting fan unit on this hood enables it to be installed in one of

four different ways:

1 - Air outlet directed upwards (ducting or recirculation fitting).

2 - Air outlet directed towards the wall (ducting fitting only).

3 - Air outlet directed to the right or left (ducting fitting only). For correct installation of

the hood, please proceed in the following stages:

4.1 - Selection of the type of installation

4.2 - Installation of the hood canopy C

4.3 - Installation of the chimney A

4.4 - Ducting or recirculation fitting

4.5 - Electrical connection and testing

4.1 - Selecting the type of

installation

1 - Air discharge towards the top

In this case the hood can be used

either in filter mode (fig. 2a) or in

suction mode (fig. 2b).

2 - Air discharge towards the wall

(fig. 3)

In this case the hood can only be

used in suction mode.

3 - Side air discharge, Lh or Rh (fig.

4a-b).

In this case the hood can only be used in suction mode.

S07_04

S07_02