Electrolux RH30WC60GSA Manuel d'installation, d'entretien et d'utilisation - Page 13
Parcourez en ligne ou téléchargez le pdf Manuel d'installation, d'entretien et d'utilisation pour {nom_de_la_catégorie} Electrolux RH30WC60GSA. Electrolux RH30WC60GSA 21 pages. 30" and 36" free standing range hood
Également pour Electrolux RH30WC60GSA : Catalogue des pièces d'usine (4 pages), Catalogue des pièces d'usine (4 pages), Catalogue des pièces (4 pages)
Imprimer la page
installing the hood
Making the electrical
connections
Electrical Shock Hazard
Warning: Turn off power at the service panel before
wiring this unit.
120 VAC, 15 or 20 Amp circuit required.
ELECTRICAL GROUNDING INSTRUCTIONS
THIS APPLIANCE IS Flqq-EDWITH AN ELECTRICAL
JUNCTION BOX WITH 3 WIRES, ONE OF WHICH
(GREEN/YELLOW) SERVES TO GROUND THE
APPLIANCE. TO PROTECTYOU AGAINST
ELECTRIC SHOCK, THE GREEN AND YELLOW
WIRE MUST BE CONNECTED TO THE
GROUNDING WIRE IN YOUR
HOME ELECTRICAL SYSTEM, AND IT MUST
UNDER NO CIRCUMSTANCES BE CUT OR REMO-
VED.
Failure to do so can result in death or electrical
shock.
•
Remove junction box cover and knockout on the
top left side.
Junction box
cover
If not already done, install 1/2" conduit connector
in j-box.
House
wiring
U.L listed
wire
electrical
conduit
Run black (live), white (neutral), and green (earth)
wires (#14 AWG) according to the National
Electrical Code or CSA Standards and local
codes and ordinances in 1/2" conduit from power
supply to j-box.
Connect black, white, and green wires from
power supply to black, white, and green/yellow
wires in j-box respectively.
These connections should be done always
making reference to the electrical diagram found
inside the hood.
Close j-box cover and reapply screws.
Mounting
the glass canopy
= With the hood mounted on the wall slide the glass
canopy over the glass supports.
Insert the glass brackets.
Insert two screws into the bracket holes, drive the
screws by hand.