Atlantis A11-UX826A-BP Manuel de démarrage rapide - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel de démarrage rapide pour {nom_de_la_catégorie} Atlantis A11-UX826A-BP. Atlantis A11-UX826A-BP 16 pages.

Imprimer la page

1.2 PACKAGE CONTENTS

Unpack the package and check all the items carefully. Also, keep the box and packing materials in case you

need to ship the unit in the future. The package should contain the following items: IP Camera with Wall

Mount kit, Quick Start Guide (English, Italian), Warranty Card. If any item contained is damaged or

missing, please contact your local dealer as soon as possible.

1.3 CABLING

 Ensure the camera is fixed (using the 3/4 screws) securely otherwise it may fall and cause injury. A KIT is

included with each IP Camera for wall and/or ceiling mounting. Use the 3/4 screw anchors to fix the base

to a flat surface (wall or ceiling).

 Now You can change the camera Pan/Tilt in order to satisfy your installation. Use the wrench to release the

screw, the adjust and move it up/down. For Bullet models the bracket should be attached directly to the

wall/ceiling using the 3/4 screws (in the previously positioned 3/4 screw anchors).

 Align the mounting rings so that the arched area is above the IR LED light (dome). Make sure the ring does

not cover any part of the IR LED light (right image) because it will reflect the light back into the camera

during nighttime. It is possible (some models) to change the zoom (4X) and the focus with the included

Allen wrench. Pay attention and slowly turn the wrench until obtaining the desired shot.

 At this point just turn on the IP Camera and connect it to the LAN.

 In the end connect the DC Adapter (isn't included) to the IP Camera or connect directly the device to PoE

Switch/Injector/NVR (only if camera is PoE).

Do not install the IP Camera outdoors and/or where it may be exposed to inclement weather

(if not an IP 66 model). All cables should be appropriately insulated for outdoor installations

(a specific plastic protection part to protect the RJ45 connection cable is included. It must

be used for outdoor installations.)

Ensure the camera is fixed securely otherwise it may fall and cause injury.

Make sure the device is securely anchored to the wall (to prevent the IP Camera from

falling). The lens must not be exposed to direct sunlight.

Failure to comply with the above conditions may damage the product and result in forfeiture

of the warranty.

1.4 CMS or NVR

Plug in the Camera power supply to an open outlet or (if PoE) connect the camera directly to a PoE

Switch/Injector/NVR. Once positioned the IPCamere these must be connected to the network where there is

the NVR or PC running the SW CMS. In the following picture is shown an example of installation.

ENG