Electrolux # Manuel d'utilisation et d'entretien - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation et d'entretien pour {nom_de_la_catégorie} Electrolux #. Electrolux # 38 pages. Over the range microwave oven
Également pour Electrolux # : Manuel d'instructions d'installation (8 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (36 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (38 pages), Livre de recettes (17 pages), Livret d'instructions (12 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'instruction (16 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages), Manuel de l'utilisateur (11 pages), Manuel d'utilisation et d'entretien (26 pages), Manuel du propriétaire (9 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'instructions d'installation (21 pages), Manuel du propriétaire (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'entretien (49 pages)

Imprimer la page
Electrolux # Manuel d'utilisation et d'entretien

Solutions to Common Problems

Solutions to Common Problems
Solutions to Common Problems
IMPOR
IMPOR
IMPORT T T T T ANT
IMPOR
IMPOR
ANT
ANT
ANT
ANT
Before calling for service, review this list. It may save you both time and expense. This list
includes common experiences that are not the result of defective workmanship or material
in your cooktop.
SURFACE BURNERS DO NOT LIGHT
• Surface Control knob has not been completely turned to LITE. Push in and turn the
Surface Control knob to LITE until burner ignites and then turn control knob to
desired flame size.
• Be sure gas supply valve is open.
• Burner ports are clogged. Clean burners. See Cleaning the Burner Grates, Burner
Caps, Burner Heads in General Care & Cleaning section. With the burner off, clean
ports with a small-gauge wire or needle.
• Power cord is disconnected from outlet (Electric Ignition Models only). Be sure cord
is securely plugged into the outlet.
• Electrical power outage (electric ignition models only). Burners can be lit manually.
See Setting Surface Controls in this Use and Care Guide.

BURNER FLAME ONLY LIGHTS HALF WAY AROUND BURNER

• Burner ports are clogged. With the burner off, clean ports by using a small-gauge
wire or needle.
• Moisture is present after cleaning. Lightly fan the flame and allow burner to operate
until flame is full. Dry the burners thoroughly following instructions in the General
Cleaning section.

BURNER FLAME IS ORANGE

• Dust particles in main line. Allow the burner to operate a few minutes until flame turns
blue.
• In coastal areas, a slightly orange flame is unavoidable due to salt air.
17