Electrolux # Manuel d'entretien - Page 14

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Electrolux #. Electrolux # 49 pages. Over the range microwave oven
Également pour Electrolux # : Manuel d'instructions d'installation (8 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'utilisation et d'entretien (36 pages), Manuel d'utilisation et d'entretien (24 pages), Manuel d'utilisation et d'entretien (38 pages), Livre de recettes (17 pages), Livret d'instructions (12 pages), Manuel d'utilisation et d'entretien (20 pages), Manuel d'instruction (16 pages), Manuel d'instruction (12 pages), Manuel d'instruction (16 pages), Manuel de l'utilisateur (11 pages), Manuel d'utilisation et d'entretien (26 pages), Manuel d'utilisation et d'entretien (38 pages), Manuel du propriétaire (9 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'utilisation et d'entretien (16 pages), Manuel d'instructions d'installation (21 pages), Manuel du propriétaire (16 pages), Manuel d'utilisation et d'entretien (16 pages)

Imprimer la page
Electrolux # Manuel d'entretien
GLMV169GSB
GLMV169GBB
GLMV169GQB
PLMVZ169GCB/C
STIRRER MOTOR
The stirrer motor drives the stirrer fan to stir the microwave
radiation from the waveguide.
HOOD LAMP
The hood lamps are mounted at the hood lamp angle on
the base cover. The hood lamps can be turned off and on by
touching the WORK LIGHT pad or the NIGHT LIGHT pad. And
also the brightness can be varied to high or low by touching
the WORK LIGHT pad or the NIGHT LIGHT pad.
Never touch any part in the circuit with your hand or an uninsulated tool while the power supply is con-
nected.
When troubleshooting the microwave oven, it is helpful to follow the Sequence of Operation in performing the checks. Many
of the possible causes of trouble will require that a specific test be performed. These tests are given a procedure letter
which will be found in the "Test Procedure "section.
IMPORTANT: If the oven becomes inoperative because of a blown monitor fuse, check the monitor switch, relay (RY)
secondary interlock relay (RY2), door sensing switch and primary interlock switch before replacing the moni-
tor fuse. If the monitor fuse is replaced, the monitor switch must also be replaced. Use part FFS-BA06/KIT
as an assembly.
IMPORTANT: Whenever troubleshooting is performed with the power supply cord disconnected. It may in, some cases,
be necessary to connect the power supply cord after the outer case has been removed, in this event,
. Disconnect the power supply cord, and then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Disconnect the leads to the primary of the power transformer.
5. Ensure that the leads remain isolated from other components and oven chassis by using insulation
tape.
6. After that procedure, reconnect the power supply cord.
When the testing is completed
. Disconnect the power supply cord, and then remove outer case.
2. Open the door and block it open.
3. Discharge high voltage capacitor.
4. Reconnect the leads to the primary of the power transformer.
5. Reinstall the outer case (cabinet).
6. Reconnect the power supply cord after the outer case is installed.
7. Run the oven and check all functions.

TROUBLESHOOTING GUIDE

4