Drill Master 68240 Manuel - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Drill Master 68240. Drill Master 68240 13 pages. 18v cordless reciprocating saw
Imprimer la pageCleaning, Maintenance,
and Lubrication
1. BEFORE EACH USE, inspect the general condition
of the tool. Check for loose hardware, misalignment
or binding of moving parts, cracked or broken
parts, damaged electrical wiring, and any other
condition that may affect its safe operation.
2. AFTER USE, wipe external surfaces of the tool with
clean cloth.
Troubleshooting
Problem
Tool will not start.
1. Battery pack not
2. Discharged Battery Pack.
3. No power at outlet during
4. Internal damage or
Trigger will not
Tool needs service check.
turn off.
Performance
1. Accessory dull or damaged.
decreases over time.
2. Carbon brushes worn
Cut line is irregular.
1. Bent, cracked, or
2. Loose saw blade.
Saw doesn't cut or
1. Dull Saw Blade.
doesn't cut properly.
2. Improper Saw Blade used.
3. Tool speed too slow.
Excessive noise
Internal damage or wear. (Carbon
or rattling.
brushes or bearings, for example.)
Overheating.
1. Forcing tool to work too fast.
2. Accessory misaligned.
3. Accessory dull or damaged.
4. Blocked motor housing vents.
Follow all safety precautions whenever diagnosing or servicing the tool. Disconnect power supply
before service.
SKU 68240
Possible Causes
properly connected.
charging.
wear. (Carbon brushes or
switch, for example.)
or damaged.
broken saw blade.
For technical questions, please call 1-800-444-3353.
NOTE: Ni-Cd BATTERY MUST BE RECYCLED
OR DISPOSED OF PROPERLY. Do not
short, incinerate or open Battery Pack.
3. When storing, always store in clean, dry and
safe location out of reach of children.
4.
WARNING! If the supply cord of the
charger is damaged, it must be replaced
only by a qualified service technician.
Likely Solutions
1. Make sure that the battery pack (sold separately)
is securely inserted into the tool.
2. Charge the Battery Pack.
3. Check power at outlet. If outlet has no power,
disconnect charger and check circuit breaker. If
breaker is tripped, make sure circuit is right capacity
for charger and circuit has no other loads.
4. Have technician service tool.
Immediately remove battery pack from tool. Do
not use tool until a qualified service technician
checks out tool for damage or defects.
1. Keep cutting accessories sharp. Replace as needed.
2. Have qualified technician replace brushes.
1. Replace saw blade.
2. Make sure blade is securely installed in tool.
1. Replace saw blade.
2. Use metal saw blades for cutting metal and
wood saw blades for cutting wood.
3. Increase tool speed by squeezing Trigger harder.
Have technician service tool.
1. Allow tool to work at its own rate.
2. Check and correct accessory to fence
and/or table alignment.
3. Keep cutting accessories sharp. Replace as needed.
4. Wear ANSI-approved safety goggles and NIOSH-
approved dust mask/respirator while blowing
dust out of motor using compressed air.
Page 9