Drill Master 95578 Manuel d'installation et d'utilisation - Page 12
Parcourez en ligne ou téléchargez le pdf Manuel d'installation et d'utilisation pour {nom_de_la_catégorie} Drill Master 95578. Drill Master 95578 20 pages. 4-1/2” angle grinder
Également pour Drill Master 95578 : Manuel d'assemblage et d'utilisation (16 pages)
Imprimer la page
SPECIFICATIONS
Electrical Input
Motor No Load Speed
Max. Accessory
Diameter
Arbor Hole Diameter
Spindle Thread
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon
as possible.
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool off and unplug the tool
from its electrical outlet
before assembling or making
any adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
SKU 95578
120 V~ / 60 Hz / 4.3 A
11,000 RPM
4-1/2" (114 mm)
7/8"
5/8" x 11 TPI
TO PREVENT
SERIOUS INJURY
For technical questions, please call 1-800-444-3353.
Assembly
Adjusting the Wheel Guard
Do not operate this tool
without the Wheel Guard
properly installed.
1.
Loosen the Wheel Guard Bolt.
2.
Rotate the Wheel Guard as needed
to shield you during the planned
work.
3.
Tighten the Wheel Guard Bolt
securely.
4.
Check the Wheel Guard to ensure it
is firmly in place. Adjust if necessary
before proceeding.
Installing the Side Handle
Do not operate this tool with
one hand only or without the
Side Handle properly
installed.
5.
The Side Handle may be installed on
either side of the Gear Housing.
6.
Screw the threaded end of the Side
Handle into the selected position.
Tighten securely before beginning
work.
TO PREVENT
SERIOUS INJURY:
TO PREVENT
SERIOUS INJURY:
REV 10d
Page 12