Atlas Copco 8433327030 Instructions relatives au produit - Page 14
Parcourez en ligne ou téléchargez le pdf Instructions relatives au produit pour {nom_de_la_catégorie} Atlas Copco 8433327030. Atlas Copco 8433327030 20 pages. Battery-powered nutrunner
Imprimer la page
Service
Service
Preventing ESD Problems
The components inside the product and controller are sensitive to electrostatic discharge. To avoid future
malfunction, make sure that service and maintenance is carried out in an ESD approved work environ-
ment. The figure below shows an example of an appropriate service work station.
Maintenance Instructions
Service Recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guide-
lines:
■
Clean appropriate parts accurately
■
Replace any defective or worn parts
Overhaul
Have your power tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
Service must only be carried out by qualified personnel who have access to the Service instruction and/or
have been trained for service on this tool.
The electric motor is a sealed unit and may under no circumstances be opened by anyone else than Atlas
Copco Industrial Technique AB.
If it is judged that the electric motor is defect or in need of service, the complete motor unit should be re-
turned to Atlas Copco Industrial Technique AB for exchange.
Motors which have been opened by anyone else than Atlas Copco Industrial Technique AB will not be ser-
viced.
Overhaul and preventive maintenance is recommended at regular intervals once per year, after maximum
200.000 tightening or 2.000.000 pulses, depending on which occurs first. More frequent overhaul may be
needed if the machine is used in heavy-duty operations. If the machine not is working properly, it should
immediately be taken away for inspection.
When dismantling the tool always use the specially designed service tool(s) recommended in the Spare
Parts section on ServAid - https://servaid.atlascopco.com.
14
EN
© Atlas Copco Industrial Technique AB - 9839 0852 01
ETP SRB 31-20-10