Bose AM267565 Manuel de l'utilisateur - Page 22

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Bose AM267565. Bose AM267565 34 pages. Bose corporation user guide speaker am267565

Imprimer la page

Steps to Installing

Figure 23

Caution against drilling

without eye protection

Tip: If necessary, use tape to hold the template temporarily in place (see TAPE HERE on the

template). Then run your pencil along the entire template edge, except where there is tape.

For ceiling installation, notice the orientation of the Bose

Make sure it will be oriented as you want it when you position the speaker in the hole you

cut. If you need the logo to face in the opposite direction, you can do so by removing the

speaker frame, rotating it 180˚ and reattaching it to the speaker. Refer to Figure 21 on page

20.

Cutting the speaker hole

You need a small saw or specialized cutting tool (for example, a keyhole or drywall saw)

for this step of the installation.

Be sure to use the proper equipment and follow all safety precautions as you cut through the

wallboard.

WARNING: Use eye protection (Figure 23) and be sure to observe all safety precautions

while using the saw or cutting tool.

CAUTION: Use care in handling tools to avoid damage to the surrounding wall area.

Insert the blade into the pilot hole and cut down and at an angle until you reach one pencil

line. Or, before you begin cutting, you may prefer to drill holes inside each corner of the

rectangular outline you have drawn, to simplify the job.

Note: Making the corners perfectly square is not important.

Tip: While it is important to cut carefully, remember that the speaker frame overlaps the

wallboard by

-inch (0.6 cm) when the speaker is in place. Minor cutting inaccuracies will be

hidden behind that frame.

AM267565_01_V.pdf May 13, 2003

logo on the speaker frame.