Bose Lifestyle 48 Manuel de dépannage - Page 7

Parcourez en ligne ou téléchargez le pdf Manuel de dépannage pour {nom_de_la_catégorie} Bose Lifestyle 48. Bose Lifestyle 48 32 pages. Personal music center ii - owner's guide
Également pour Bose Lifestyle 48 : Manuel d'installation (42 pages), Manuel (29 pages), Manuel d'installation (36 pages), Manuel du propriétaire (25 pages), Manuel du propriétaire (24 pages), Manuel du propriétaire (13 pages), Manuel d'installation rapide (3 pages), Manuel du propriétaire (30 pages)

PS18/28/35 Troubleshooting Guide

Theory of Operation

1.4 High-frequency Resonant Converter

This section describes the theory of operation for a high-frequency half-bridge resonant DC-DC

converter, the heart of the power supply. Figure 5 shows its detailed circuit, where the high-fre-

quency transformer is represented by a leakage inductor Llk, a magnetizing inductor Lm, and an

ideal step-down transformer.

Figure 5. High-frequency half-bridge resonant DC-DC converter

With gate signals from the controller IC, the two power MOSFETs Q101 and Q102 are turned on

and off alternately to invert the DC input voltage to a high-frequency square wave voltage. The

high-frequency square wave voltage is applied to a series resonant circuit made of a resonant

capacitor C115 and leakage inductor Llk of the transformer. The resonant circuit shapes the

current waveform to a quasi sinusoidal waveform. Figure 6 shows oscillograms of the voltage

across MOSFET Q101 and current through capacitor C115. Such a smooth current waveform

lowers electromagnetic interference (EMI) emissions from the power supply.

Figure 6. MOSFET Q101 voltage and C115 current waveforms

The transformer transfers high-frequency power from the primary winding to two secondary

windings. The rectifier diodes D201A, D201B, D203, D204 rectify the high-frequency power and

the two capacitors C201 and C202 filter out high-frequency contents. A low pass L-C filter is

added to each rail to further reduce the high-frequency noise. Two DC voltages, one positive and

one negative, are obtained at the output.