Bose Lifestyle PS48 Manuel d'entretien - Page 35

Parcourez en ligne ou téléchargez le pdf Manuel d'entretien pour {nom_de_la_catégorie} Bose Lifestyle PS48. Bose Lifestyle PS48 43 pages. Digital acoustimass powered speakers
Également pour Bose Lifestyle PS48 : Procédure de test (5 pages)

Imprimer la page

Placing the Bass Module into TAP Mode

Place all four DIP switches to the down position before returning the unit to the customer

1. Place the bass module into TAP mode

1.1 Set all four DIP switches into the "up"

position. Apply power to the bass module

using the AC line switch and wait until the

amber LED blinks twice and the green LED

blinks briefly at least once (approximately 3

seconds after power up). Then, within twenty

seconds, flip ALL four switches down, then

flip switch #4 (closest to the RJ-45 connector)

back up. The unit will now communicate in

TAP mode. The amber and green LED will

blink alternately when no S/PDIF signal is

applied. Note that when TAP mode is acti-

vated in this manner, the DSP will echo

characters sent by the terminal.

Figure 12. DIP switch Up/Down orientation

Type the equalization setup command

SE [SPEAKER TYPE], [EUROPEAN BASS],

[EUROPEAN TREBLE]

Command

SPEAKER

TYPE

A = singleshot (18) ON

D = doubleshot (28)

C = cricket (35)

U = User EQ

Example: To set the equalization to cricket

cubes, euro bass off and euro treble off, type

the command as follows. SE C,OFF,OFF

Down

Setting the Equalizer

Condition

EURO

BASS

TREBLE

OFF

PS18/28/48 Service Manual

2. Verify the bass module communicates in

TAP mode.

2.1 Connect the test cable's, part number

264564, DB-9 connector to the RS-232 COM

port on your computer. Connect the test

cable's RJ-45 connector to the bass module.

2.2 Type the command ST S and hit "Enter".

The following response should be seen on

your computer screen. The results may differ

depending on the unit settings. If no S/PDIF

signal is applied, the sample rate will be 29

kHz.

SAMPLE RATE : 44101.30

SPKR TYPE

: 02

DIP VALUE

: 1111

LCRB_MUTE

: 1

LSRS_MUTE

: 1

SAT_CLIP

: 1

BASS_CLIP

: 1

EURO_BASS

: 1

EURO_TREBLE : 0

2.3 Check the software by typing (issuing)

the command TN 4 and then hitting "Enter". A

typical response would be as follows.

03DE6455, 010808

03DE6455 is the checksum

010808 is the software version

Verify the changes have been made by typing

the command ST S.

The speaker type (SPKR TYPE) and other

information will be displayed. Decode the

numerical two digit speaker type as follows.

01 Doubleshots (Later version dual cube)

02 Cricket (Jewel

Cube)

128 Dublin (Single Cube)

05 User EQ (ADATiQ

audio calibration)