Bose SLINKMOBILE2 Manuel du propriétaire - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Bose SLINKMOBILE2. Bose SLINKMOBILE2 24 pages. Owner's guide
English
Tab 2, 10
Information about products that
generate electrical noise
This device complies with FCC and Industry Canada RF
radiation exposure limits set forth for general population.
This device must not be co-located or operating in
conjunction with any other antennas or transmitters.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
U.S.A. only
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
this is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning
Tab 3, 11
Tab4, 12
Tab 5, 13
Tab 6, 14
the equipment off and on, you are encouraged to try to
correct the interference by one or more of the following
measures:
• Re-orient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment to an outlet on a different circuit
than the one to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Any changes to this device not expressly approved by
Bose Corporation may void the user's authority to operate
this device.
Canada
This device complies with Industry Canada licence-exempt
RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and
(2) this device must accept any interference, including
interference that may cause undesired operation of the
device.
This device complies with FCC and Industry Canada RF
radiation exposure limits set forth for general population.
This device must not be collocated or operating in
conjunction with any other antennas or transmitters.
Tab2, 7, 15
Tab 8, 16
S
I
AFETY
NFORMATION
5