Bose Acoustimass 3 Series IV Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Bose Acoustimass 3 Series IV. Bose Acoustimass 3 Series IV 22 pages. Bose acoustimass 3 series iv speaker system owner's guide
Également pour Bose Acoustimass 3 Series IV : Manuel du propriétaire (17 pages)

Bose Acoustimass 3 Series IV Manuel du propriétaire
Selecting a location for the Acoustimass" module
The Acoustimass module can be hidden almost anywhere in a room Leave at least 2 inches
(5 cm) of space between the opening (port) and the wall To prevent interference, keep the
module at least 2 feet (0 6 m) from any video screen
For a balanced sound in most rooms, place the module along a wall within 5 feet (15m) of the
corner To increase bass response, move the module closer to a corner without blocking the
opening To decrease the bass, place the module farther from the corner
)
Note:
When you decide how you will position the module, attach the rubber feet to the
bottom surface to protect the module and the floor
Figure
2
Choices on how to position the
module
Using the cables correctly
Use the supplied cables to connect the cube speakers to the module and the module to your
amplifier or receiver
A.
CAUTION:
Be sure all components are turned off and unplugged from the power outlet
before making the connections
To place these components more than 20 feet (6 2 - 9 2 m) apart, you will need to splice in a
length of 18-gauge speaker cable To place them more than 30 feet (9 2 m) apart, you will
need heavier gauge wire (See the wire recommendations on page 10 ) You can get additional
speaker cable at electrical and hardware stores or by calling Bose Customer Service (See
the list of phone numbers inside the back cover)
Speaker cables consist of two insulated wires The insulation around one wire is marked with
a band or stripe This marked wire is always positive
(+)
The plain wire is always negative (-)
These correspond to the red (+) and black (-) terminals on the back of the speaker, amplifier,
or receiver Be sure to connect each wire to the proper terminal (positive to positive, negative
to negative)
5