Bose L1 Model I Manuel du propriétaire - Page 26
Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Bose L1 Model I. Bose L1 Model I 32 pages. Troubleshooting
Également pour Bose L1 Model I : Manuel d'installation rapide (2 pages), Dépannage (2 pages)
O
I
PERATING
NSTRUCTIONS
Figure 8
Using a serial effects
connection
26
Using a serial effects connection with the L1 model I power stand
Note: Connecting an effects unit in serial requires a TRS split "insert" cable (with a ¼-inch TRS
connector on one side, and two mono ¼-inch phone connectors on the other). This type of cable
is readily available at most musical instrument stores and on the Internet.
1. Insert the TRS plug into the Channel 1 Insert jack on the L1 model I power stand.
2. Connect the ¼-inch mono plug (labeled "send", "ring", or "right") to the input of the
effects processor.
3. Connect the other ¼-inch mono plug (labeled "return", "tip", or "left") to the output of the
effects processor.
4. Adjust the effects level and mix of the effects processor.
Note: A very high output from the effects processor can overload the input of the L1 model I
power stand. If the LED on the remote turns red, even if the channel LEVEL control on the R1
remote control is below the 12 o'clock position, reduce the output level of your effects processor.
Note: The effects processor does interrupt the audio path. This may result in no audio output if
the effects processor is turned off. To use a "clean" signal, do not turn the effects processor off,
but put it in bypass mode.
Connect to
Channel 1 Insert
L1 model I power stand
TRS
TRS split "insert" cable
(Return, Left or Tip)
Connect to Effects Unit
OUTPUT
(Send, Right, or Ring)
Connect to Effect Unit INPUT
Digital Effects Unit