Bose FreeSpace E4 Series II Manuel du propriétaire - Page 5

Parcourez en ligne ou téléchargez le pdf Manuel du propriétaire pour {nom_de_la_catégorie} Bose FreeSpace E4 Series II. Bose FreeSpace E4 Series II 33 pages. Business music system
Également pour Bose FreeSpace E4 Series II : Manuel du propriétaire (18 pages), Manuel de démarrage rapide (4 pages), Manuel du propriétaire (16 pages), Manuel du propriétaire (15 pages)

Launch the FreeSpace

The Installer software splash screen will appear on your screen.

After the splash screen, a status dialog will appear and report the

status of each installation stage.

Programmer's Note: Clicking the Close button on the

hardware connection status dialog will cause a communi-

cations failure, locking the serial port.

At this point in the installation, the software looks for a

connected E4 system, and if found, then checks to see

what version firmware is running in the E4 system.

If you get a "No hardware detected" dialog, see "No

hardware detected" on page 36.

If you get an Incompatible Microcontroller code dialog,

see "Incompatible microcontroller code" on page 36.

If prompted, select the correct COM port for the E4

hardware.

By default, the Installer software tries to locate a hardware device

on the COM 1 serial port. If the E4 hardware is not detected on

COM 1, the software displays a "Choose COM port" dialog box

asking you to select the correct serial port.

5.0 Using FreeSpace

Installer™ software.

Installer™ Software

Programmer's Note: If you encounter the "Choose

COM port" dialog box, immediately follow the displayed

recommendations for correcting the problem. DO NOT

click the Cancel button until after trying each of the

given recommendations.

Programmer's Note: Before dismissing the "Choose COM port"

dialog, select the COM 2 port and click Try Again. Not doing this

will cause the COM 1 port to be locked.

After your PC successfully connects to the E4 hardware, the

Choose COM port dialog should automatically close. If not, close

the window manually.

If you have connected to a new E4 system, use the E4

front panel window to set up the hardware.

Refer to the "E4 System Setup" on page 44.

35 of 80