Drolo Stamme n Manuel - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel pour {nom_de_la_catégorie} Drolo Stamme n. Drolo Stamme n 4 pages.

MODE rotary switch:

8 different operation modes divided in two groups

TT (Tap Tempo): The bypass switch starts the loop. Maximum sample size is 1sec. The function switch is

used to tap the tempo. Its action is triggered on release. So if you are tapping to a beat, count your releases

not your presses. The control knob can be used to set the sample size manually, even after a tempo has

been tapped.

RT (Random Tempo): Each time you press the bypass switch, the loop starts with a different, random tempo

(smaller or larger sample sizes). The function switch slightly changes the delay time each time you press it

so that you can gradually de-tune and degrade the ongoing loop. The control knob can be used to set the

sample size manually.

GL (Glitcholay): This mode was adapted from the Pitch Glitcholay patch available in the Molecular pedal

series. The sample size randomly changes and randomly loops. The function switch (momentary) adds

feedback with an octave up pitch shifter. The control knob defines the rate at which the random states

change.

TL (Tape Loop): Another effect adapted from the molecular patches. Works like a loop of 1 second of tape

that can be sped up or slowed down with the control knob. In the middle position the loop runs at normal

speed/pitch. CW is double speed. CCW is half speed. The function switch (momentary) can loop the current

sample.

SW (Swell Hold): The bypass switch starts the effect and freezes the ongoing sample. The control knob

defines how fast the held sample fades in and out. The function switch can be used to add another layer of

audio or change the sampled audio without having to stop the previous one. NOTE: in order to allow the

sample to fade out appropriately, in this mode the effect is still going through the DSP chip even when

bypassed.

PT (Pitch Hold): The bypass switch starts the effect and freezes the ongoing sample. The control knob

detunes the held signal when turning CCW (like slowing down a tape). The function switch can be used to

add another layer of audio or change the sampled audio without having to stop the previous one.

FL (Filter Hold): The bypass switch starts the effect and freezes the ongoing sample. The control knob goes

from a low pass filter on the left to a high pass filter on the right. The function switch can be used to add

another layer of audio or change the sampled audio without having to stop the previous one.

ST (Stutter Hold): The bypass switch starts the effect and freezes the ongoing sample, stuttering (like a

random step tremolo). The function switch (latching) applies the stutter to the dry signal.

NOTE: if you would like to use the stutter effect on the dry signal only you can turn down the wet signal,

engage the effect with the bypass switch and turn on the stuttering with the function switch.