Dromida KODO FPV Manuel de l'utilisateur

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Dromida KODO FPV. Dromida KODO FPV 8 pages.

Imprimer la page

READ THESE

INSTRUCTIONS

BEFORE

BEFORE FLYING !

Controller

Flight Battery

CONTROLLER

Phone Holder

Picture

Throttle

Button

Trim

Throttle/Rudder

Rudder

ON/OFF Aileron

Stick

Trim

CHARGING the FLIGHT BATTERY

Plug charger into USB port or AC adapter (DIDP1125 not included)

as shown and connect the battery. The red LED will flash slowly

while the battery is charging. The LED will be steady when the

battery is fully charged.

• NEVER leave the battery unattended while charging.

• DO NOT allow the USB port to power down while the charger

is connected to the battery.

• ALWAYS unplug the charger from the USB port and the

battery when charging is complete.

• The battery connector will only fit in one way.

FLYING !

Spare Blades

(2 black, 2 red)

KODO

™

Drone

Elevator

Video

Trim

Button

Remove the screw on

the battery compartment

cover. Take the cover off

and insert 4 AAA batteries.

Replace cover, securing

Aileron/Elevator

Trim

Stick

with the screw.

SETUP

Your KODO FPV comes with a Power-On Fail-Safe. This ensures that

the motors will not start until the KODO has detected the controller.

The KODO FPV's motors are now armed and the quad is ready to

fl y. The red LED on the KODO FPV will become steady.

FPV Headset

4 AAA Batteries

SENSITIVITY ADJUSTMENT

Push down on the left stick to

Lowest (Default)

• Do not mix old and new batteries.

• Do not mix alkaline, standard, or

rechargeable batteries.

1. Turn on the controller with the throttle

at its lowest position.

2. Connect the battery to the KODO

FPV and place it on a level surface.

Listen for two beeps. The red LED at

the back of the quadcopter will start

fl ashing slowly.

3. Move the throttle to its highest position. Listen for a beep.

4. Move the throttle back to its lowest position. Listen for three

beeps.

™

USB

Charger

Screwdriver

change the sensitivity

of the controls.

Moderate

Maximum