Beckmann+Egle MD3060 Manuel d'instruction - Page 6

Parcourez en ligne ou téléchargez le pdf Manuel d'instruction pour {nom_de_la_catégorie} Beckmann+Egle MD3060. Beckmann+Egle MD3060 16 pages.

MD3150/3060

Operating modes

Temperature indication and interface output

Mode 0:

Mode display

The current temperature value is displayed in this mode.

In addition, temperature values can be output via the serial interface in this mode. A

condition is that the small display is 'ON' in mode 1 of the device.

If the measurement is taken on-line, note that the automatic switch-off function 'AoFF'

is 'OFF' in mode 7 of the device.

Only MD3150:

Press the plus key to select the required measuring channel.

C1, C2 -> displays the temperature of measuring channel 1 or measuring channel 2

C12

Press the minus key to change the temperature display between units of °C and °F.

Switching the serial interface on/off, output of

Mode 1:

measured values in the memory

Mode display

If the small display is 'ON', briefly pressing the minus key causes output of the

measured values in the memory via the interface.

At the same time the measured values can also be viewed in the temperature display

and the small display always shows the appropriate memory location number.

Pressing the minus key again while measured value data is output stops the output.

Pressing the plus key enables (ON) or disables (OFF) the output of measured values

via the interface.

If 'ON' measured value data output is continuous (in mode 0) via the interface (at a

frequency of about 1 value per second).

-> temperature display alternates between both channels every 2 seconds

Small display

ON or OFF

Page 6

Large display

Current temperature

Large display

Internet: www.bue.de