Ankom TDF23 Procédure de service - Page 4

Parcourez en ligne ou téléchargez le pdf Procédure de service pour {nom_de_la_catégorie} Ankom TDF23. Ankom TDF23 9 pages. Paddle bar replacement

Imprimer la page

11.

Place the four shims in their appropriate positions.

Set the four 0.015" Shim spacers (provided in the new

Paddle Bar kit) underneath the #1, 2, 5 & 6 paddles and

set on top of Clamp Bar B to properly distance the

Paddle Bar Assembly from Clamp Bar B. When doing

this, allow the paddles to rest on the shims while tilting

the paddles back so that the bottom front corner of each

paddle is the only part of the paddle that is touching the

shims. In this position the face of the paddles will not

be perfectly vertical but slightly tilted back at the

bottom.

With the paddles held in a tilted back position, tighten

the four screws in the Paddle Bar Hinge Posts using the

5/32" Hex key wrench.

Once the screws are tight, remove the four Shim spacers

from beneath the paddles.

12.

Plug the 25 pin Cable Connector into its socket in the

underside of the Electrical Enclosure.

Carefully tilt the instrument forward.

Make sure the cable is not caught up in the tubing or air

lines in the back of the instrument.

When plugging the connector in, align the pins to the

sockets within the connector and twist clock-wise until

it stops turning.

Check to make sure it cannot be pulled out (it should

lock in place).

13.

Finger-tighten the Shoulder Screw.

This will connect the cable block (on the Paddle Bar

Assembly sticking through the hole in the front of the

instrument) to the brass Rod End of the Mixer Piston in

order to secure the Paddle Bar while testing it in the

following steps.

ANKOM Technology  2052 O'Neil Road  Email: [email protected] Phone: 315-986-8090  Fax: 315-986-8091

Paddle Bar Replacement

TDF

Service Procedure

Shim

Spacers

underneath

Paddle

Align

Cable

Connector

Sockets

Shoulder

Screw

TS021

Revised: 01/24/2017

pg. 4 of 9