DrumCraft 8 series Instructions de montage - Page 3

Parcourez en ligne ou téléchargez le pdf Instructions de montage pour {nom_de_la_catégorie} DrumCraft 8 series. DrumCraft 8 series 4 pages.

Imprimer la page

Claw

Bearing

Edge

Fold the Spur forward

Tom

Holder

Tom

Bracket

Knurled

Nut

Basket

Bottom

Section

1. Place the bass drum (R) on the floor, so the bearing edge points

towards the top.

Hoop

2. Place the white BD head (B) on the bearing edge, and center the logo

Head

so you can read it.

3. Center one of the BD hoops (C) onto the aluminium ring of the head.

4. Slide the one nylon washer (F) on each BD tension rod (D).

Spur

5. Slide the tension rod including washer into the BD claw hooks (E).

6. Position every tension rod, washer claw hook unit onto the hoop and

screw the tension rod into the receiver nut of the lugs. Tighten the

tension rod by hand only. Tuning will be done later.

7. Turn the shell upside down.

Lug

8. Repeat step 1– 6 on the batter side of the drum with the clear head.

9. Set the shell right side up.

10. Loosen the spur's wing nut and angle the spur forward to the deter

mined slots and fix it again.

11. Extend the spur by loosen the square head screw with the drum key.

Fix the legs so the front end of the BD is lifted about 3 cm (two fingers

wide) off the ground.

12. Mount the multi clamp (M) to the middle section of the cymbal stand.

13. Insert the tom holder (N) into the remaining supportof the clamp.

14. Loosen the wing screw of the tom bracket of the rack tom (O, P) to

slide onto the tube of the tom holder. The nose of the memory lock

should snap in the notch of the bracket.

15. Tighten the wing screw of the bracket.

16. Set the angle and height of the toms that an imagined line of the batter

head points towards your hip.

17. Position the floor tom legs in the brackets and tighten the wing screws.

18. Set the height of the tom as an imagined line from the batter head

points towards your hip.

19. Spread the legs on the bottom section of the Snare Stand (H) and

tighten the wing screw. Slide the tube of the top section into the base

section and tighten the wing screw on the tube joint.

20. Tip the basket of the stand to an upright position and spread it open

by hand, if it doesn't open as wide as you need for the snare, use the

knurled nut to fine adjust the width.

21. Place the Snare onto the basket and tighten the knob so the three arms

embrace the snare drum with no tension.

Bd a

SSemBly

Bd S

etuP

ack

omS

loor

SSemBly

nareStand