DRY AGER DX 1000 Manuel de l'utilisateur - Page 11
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} DRY AGER DX 1000. DRY AGER DX 1000 14 pages.
Également pour DRY AGER DX 1000 : Manuel d'utilisation (17 pages)
Imprimer la page
Changing the door hinge
The door hinge should only be changed by trained specialists. Two
people are required for the modification.
1. Open the door approx. 130°.
2. Unscrew the screw from the
hinge bracket and screw it 3-4
turns into the bearing pin.
Attention
The door must now be held by a
second person.
3. Pull out the bearing bolts.
4. Slightly tilt the door to the side
and remove it upwards.
20
5. Disengage the cover with a
small screwdriver and remove.
6. Unscrew the lock and assemble
it again on the opposite side.
7. Snap the cover into place.
8. Disengage pressure plates at
the front
and pull them
off to the rear
.
9. Unscrew the handle and screw
it back on the opposite side.
16. Slide the cover (with the
smaller opening) inwards
from the outside and snap it
into place.
10. Push on the pressure plates
until they engage.
11. Disengage the covers on the
inside, slide them outwards
and remove them.
12. Unscrew the hinge bracket.
13. Unscrew the closing bracket.
14. Screw the closing angle on
the opposite side again.
15. Screw the hinge bracket back
on the opposite side. Screw
3 screws into the marked
openings.
17. Guide the cover with the
larger opening over the hinge
bracket, slide it inwards from
the outside and snap it into
place.
18. Loosen the adjustable foot
with the enclosed wrench.
19. Pull the bolt upwards and
unscrew it from the adjust-
able foot.
20. Pull out the adjustable foot
downwards.
21. Unscrew the hinge bracket.
22. Replace the cover on the opposite
side.
23. Remove the cover, turn it 180°
and replace it on the opposite
side.
21