Absolare Hybrid Mono Amplifier Manuel de l'utilisateur - Page 8

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} Absolare Hybrid Mono Amplifier. Absolare Hybrid Mono Amplifier 12 pages.

Absolare Hybrid Mono Amplifier Manuel de l'utilisateur

6. Operating the Unit

6.1. General Operation

Before turning on each Absolare Hybrid Mono Amplifier, be sure that all tubes are
installed and all cables are connected securely.
After turning each Amplifier on, the power indicator LED on the front face plate will
start to blink. You will not hear any sound until the indicator LED stops blinking to
illuminate continuously which indicates all the capacitors are charged and internal
voltages are stabilized.
Absolare Hybrid Mono Amplifiers will be ready to operate approx. 40 seconds after
turning on the power but attain full performance after 15 to 30 minutes.
There is requirement for matching tubes to optimise performance. You can try
different types / brands of 12AU7/ECC82 compatible tubes in left and right tube
positions within each Amplifier. Different tubes will impact sound quality. It is
important that the final selection of input tubes for one Amplifier are copied in the
other Amplifier, so that both left channel and right channels are identical.

6.2. SEL Switch

Selects the active input connection, XLR or RCA connector. The unselected input is
terminated with a 620Ω resistor.

6.3. 'PIN 1' Switch

Selects whether the number 1 pin of the XLR connector will be connected to ground
(
) or left unconnected (
). It is advised to set this switch to ground (
).
GND
FLOAT
GND
Since there is no strict standard on XLR grounding, it might be necessary to use this
switch to solve some grounding problems. The XLR's outer connector casing is
connected to each Amplifier's chassis.

6.4. GND Switch

Selects whether the input signal ground will be directly connected to the chassis or to
a 'lifted' signal ground (a separate clean ground plane inside the amplifier, connected
to chassis through a filter). It is advised to set this switch to
, unless there is a
SIGNAL
ground related hum in your system.
8
ABSOLARE Hybrid Mono Amplifier User Manual 1.2