3M 3M034-031-TNG Manuel de l'utilisateur - Page 9
Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 3M 3M034-031-TNG. 3M 3M034-031-TNG 15 pages. Em aware tng esd event monitor, including starter kits
Imprimer la page
Changing the ESD Event Parameters
1. To reset the ESD counter to zero, press the joystick momentarily.
2. To change the ESD threshold, press the joystick longer until "ESD" is
displayed. Move the joystick left or right to decrease or increase the threshold
value. On this screen, a "REF" symbol appears on the top left corner.
3. To disable or enable CDM filter, move the joystick up or down to "on" or
"off " CDM filter. A PEAK symbol appears on screen when the ESD filter
is active.
4. To finalize the settings, push the joystick longer until the main ESD Event
screen appears. A "MEM" symbol appears momentarily in this process.
ESD Event Mode
ESD Threshold Level
ESD Threshold Marker
Change in the Static Voltage - Parameters
1. At the main screen display (no "REF" symbol), move the joystick until the
display is as shown above.
2. To reset the over-threshold counter to zero, press the joystick momentarily.
3. To change the voltage range and thresholds, push the joystick longer until a
new screen appears. The new screen shows a "REF" symbol at the right top
corner.
4. Move the joystick up or down to scroll on the voltage range options.
5. Move the joystick left or right to decrease or increase the static voltage
threshold.
6. To finalize the settings, push the joystick longer until the screen shows the
main static voltage screen.
Static Symbol
Dot Level Graphics
ESD Event Main Screen
8
MAX - maximum
PEAK - ESD mode
ESD Counter
ESD Threshold in dBuV
Over-threshold Counter
Change in Static Voltage measured, V