Drytac HOT PRESS HGP260 Manuel de l'opérateur - Page 5
Parcourez en ligne ou téléchargez le pdf Manuel de l'opérateur pour {nom_de_la_catégorie} Drytac HOT PRESS HGP260. Drytac HOT PRESS HGP260 19 pages. Heated glass top vacuum press
Également pour Drytac HOT PRESS HGP260 : Manuel de l'utilisateur (19 pages)
Imprimer la page
SAFETY CONSIDERATIONS
This product should only be used for the purpose and manner for which it was designed.
Before installing and using the equipment, please read this entire manual and be sure that you
understand all the aspects of proper use. Some of the more important safety considerations
are listed below.
•
Ideally, the vacuum press should be used with a metal stand (available from Drytac). If a stand
is not used, the press must be located on a sturdy table or countertop capable of supporting its
weight (refer to Technical data in this manual). The largest model (HGP560) is supplied with a
stand, which must be used due to the weight of the unit.
•
Connection of the equipment to the power source must be handled by a qualified electrician
familiar with local and national electrical codes. It is mandatory that the equipment be properly
grounded.
•
The gas struts which support the lid are a critical safety item. They must be fully extended (in
other words, the lid must be open completely) in order for them to support the weight of the lid.
The press must be installed in a location which allows the lid to be completely raised without
interference. If the lid is only partially opened, it may close unexpectedly.
•
Before each use, the struts should be checked to be sure they are operating properly. Over a
period of time, the struts will lose pressure and will eventually require replacement.
•
The inner surface of the glass top is very hot during normal operation. Be very careful
not to touch the glass when inserting or removing materials from the press.
•
Before servicing the equipment, it must be disconnected from the power source.
•
If either of the circuit breakers on the rear panel of the unit should trip repeatedly, unplug the
equipment and have it serviced. The same applies to the fuses on the side panel.
•
The vacuum press incorporates a high-temperature safety cutout device, which disconnects all
power from the unit if the internal temperature reaches a predetermined level (257° F / 125° C).
If the unit unexpectedly shuts off during use and later comes back on after cooling down, it is
likely that this safety device has activated. This indicates a problem with the temperature
control system, and the unit should be repaired by a qualified technician.
•
Do not use a knife to cut materials while they
are inside the press. This could cause damage
to the diaphragm.
SETTING UP YOUR NEW VACUUM PRESS
Equipment Location: The smaller vacuum press
models such as the HGP220 and HGP260 may be
used on a table or countertop, provided that it is
able to support the weight of the equipment. The
5