3M C1510PS Manuel de l'utilisateur - Page 17

Parcourez en ligne ou téléchargez le pdf Manuel de l'utilisateur pour {nom_de_la_catégorie} 3M C1510PS. 3M C1510PS 20 pages. Dual-touch chassis display

Imprimer la page

3M™ Dual-Touch Chassis Displays User Guide

Error Messages

If you see error messages on your LCD screen, this means that the LCD display cannot

receive a clean signal from the computer graphics card. Below are the basic error

messages.

Pressing Menu will pull up the On Screen Display (OSD) menus to control the Picture,

Color, Display, OSD Settings, and Setup.

Please refer to the 3M Touch Systems website at

information.

No Signal

The LCD display has been powered on but cannot receive any signal from the computer

graphics card. Check all the power switches, power cables, and VGA signal cable.

Going to Sleep

The LCD display is in power save mode. In addition, the LCD display will enter power

save mode when experiencing a sudden signal disconnect. The monitor can be activated

by pressing any key, clicking the mouse or touching the screen.

Out of Range

The signal of the computer graphic card is not compatible with the LCD display. When

the signal is not included in the "Video Display Modes" listed in Chapter 2 of this

manual, the LCD monitor will display this message.

Touch Screen Driver Installation

The Dual-Touch Chassis Displays come with USB connections. The touch driver is

located on the enclosed CD-ROM for these operating systems: VISTA, XP, 2000, CE,

XP Embedded, Linux, Apple® Mac OS.

Note:

The Dual-Touch Chassis Display is Microsoft® Windows® HID (Human Interface

Device) compatible if you use the USB touch screen interface. No additional

software driver is required for general operation of the touch screen.

For Dual-Touch Chassis Displays, the system requires 15 seconds for Windows 7 to

install/uninstall the touch drivers while turning power on/off or plugging/unplugging

USB cable.

Driver Install Instructions

Using VISTA, XP, 2000

1. Power on the PC.

2. Be sure the USB cable is connected from the PC to the LCD display.

3. Open the CD-ROM.

4. Follow the step-by-step instructions as shown on the pop-up windows.

3M Touch Systems, Inc. Proprietary Information – TSD-42846A

www.3m.com/touch

for additional