DS Produkte PH15006 Manuel d'instructions - Page 4

Parcourez en ligne ou téléchargez le pdf Manuel d'instructions pour {nom_de_la_catégorie} DS Produkte PH15006. DS Produkte PH15006 8 pages.

Imprimer la page

Inserting/changing batteries

ATTENTION!

•

Change batteries as soon as you notice a drop in power.

•

Always make sure that the device has been switched off before

inserting/changing batteries.

1. Turn the battery compartment cover

2. Then pull the battery compartment

3. If applicable, remove the empty batteries and dispose of them

in an environmentally-friendly manner.

4. Insert two 1.5 volt type AA batteries. When inserting the bat-

tery, always make sure that the polarity is correct (+/–).

5. Put the battery compartment cover back on the battery com-

partment and turn it into the closed position.

Changing the roller

ATTENTION!

•

A damaged roller could cause injury to skin and must be replaced.

•

Make sure that the device is deactivated before you change

the roller.

•

Replace the roller if it is worn!

1. To change a roller, depress the re-

2. Mount the new roller head on the device. It must audibly lock

into place. Please keep in mind that the roller head can only be

mounted in a speciﬁ c position: Mount the roller head on the de-

vice so that the small gear on the roller head is able to extend

into the gears of the device!

3. Make sure that the roller head is ﬁ rmly seated.

Use

ATTENTION!

•

Check the device / roller for damages as well as for wear and

tear prior to each use.

•

Make sure that you do not inadvertently push the roller's re-

lease button during use!

•

Only use the device on dry, thick and uninjured calluses on

your feet.

•

Stop using the device immediately if you experience pain or

irritation of the skin!

•

Never use the device for more than 2-3 seconds on any part

of your skin.

•

Do not forcefully push the roller onto your skin. This could injure it.

•

To prevent accidents, keep the device away from the hair of your

head, eyelashes, eyebrows, textiles, cables or laces.

Preparing the skin

Wash and dry your feet thoroughly before using the device. Make

sure that there is no residue from cream or skin care oil on your

feet.

Removing calluses

1. Remove the protective lid from the device.

2. To remove thick calluses (e.g. on the heels) you need the coarse

roller. Use the ﬁ ne roller to remove dry and thin callused areas.

DS Produkte GmbH, Am Heisterbusch 1, 19258 Gallin, Germany •

one quarter towards the arrow mark

Open on the battery compartment.

cover off.

lease button on the device and pull

the roller head off of the device.

Customer Service / Importer:

*) Calls subject to a charge. Costs vary depending on the provider.

3. Turn the device on by pushing and holding the safety switch

for the On/Off switch and pushing the On/Off switch up simul-

taneously.

4. Place the rotating roller on the calluses to be removed and

move the device back and forth and to the sides of the cal-

luses. Move the device slowly without applying pressure. No-

tice: Pressing the device too ﬁ rmly against the skin will stall

the roller to prevent injury to the skin. Be careful when handling

the unit!

5. After use, turn the device off by pushing and holding the safe-

ty switch for the On/Off switch and pushing the On/Off switch

down simultaneously.

After treatment

1. Apply cream to your feet after treatment.

2. Clean the device after you are ﬁ nished using it (see section

"Cleaning and storage").

3. Place the protective lid back on the device when not in use

Cleaning the device

ATTENTION!

•

Clean the device after every use!

•

Do not immerse the device in water or other liquids. It is only

splash-proof.

•

Do not use any corrosive or abrasive cleaning agents to clean

the device. They could damage the surface

1. Use the enclosed cleaning brush to clean the roller head and if

necessary brush off any skin ﬂ akes.

2. If necessary, wipe the device off with a damp cloth.

3. Place the protective lid on the roller.

4. Store the device and accessories in a dry place out of the reach

of children and animals.

Technical data

Product number: Z 04520

Model number:

Voltage supply:

Disposal

The packaging material is recyclable. Dispose of the

packaging in an environmentally-friendly manner and make

it available to the collection service for recyclable materials.

Dispose of the product in an environmentally-friendly

manner. The product does not belong in the household

garbage. Dispose of it at a recycling centre for old electric

and electronic equipment. For more information, please

contact the administration in your community.

Batteries and rechargeable batteries must be removed

and disposed of separately before disposing of the

product. To protect the environment, batteries and

rechargeable batteries may not be disposed of together

with normal household waste. Instead they must be turned

in at appropriate collection points. Please also observe

applicable statutory provisions regulating the disposal of

batteries.

PH15006

3 Volt DC (2x 1.5 volt batteries, type AA)

✆

+49 38851 314650 *)

Instructions